Fitting/Removing Attachments; Drying And Styling Hair; Technical Data - Silvercrest SHAC 2400 C2 Kurzanleitung

Please note, however, that the ionisation function only works optimally if the
attachments (volume diffuser 6/wide styling nozzle 7/narrow styling nozzle 8)
are removed, as an attachment will interfere with the application of ions to the
hair. Therefore, use the hairdryer without attachments for maximum ionisation
effect.

Fitting/removing attachments

To fit one of the attachments (wide styling nozzle 7, narrow styling nozzle 8,
■
volume diffuser 6), push it onto the front of the hairdryer with slight pressure so
that the attachment snaps into place and is evenly seated on the hairdryer.
■ Always wait until an attachment has cooled down before removing it.
Remove the cooled attachment from the hair dryer by pulling it downwards
with a firm motion.

Drying and styling hair

■ To dry hair quickly, we recommend starting with a high airflow rate and heat
setting for a short period. Once the hair has dried, switch to a lower airflow
rate and heat level to shape the hairstyle.
You can use the wide styling nozzle 7 to dry small sections of your hair
■
especially fast, because the airflow is concentrated through the wide styling
nozzle 7.
The narrow styling nozzle 8 is ideal for precisely styling and shaping your
■
hair. The airflow is slightly reduced by the openings on the side of the narrow
styling nozzle 8 which enables precise styling of the hair.
Use the volume diffuser 6 to shape natural curls/waves or give volume to
■
your hairstyle. To style natural curls/waves, hang your head downwards and
place your hair loosely on the volume diffuser 6. While drying, slowly turn
the hair dryer back and forth. Before you comb out your hair, let it cool briefly
so that the hairstyle stays in shape.
To give your hairstyle more volume at the hairline, use no more than the medi-
um heat level (see section Heater and blower levels). Hold your head up-
right and hold the volume diffuser 6 against your head. Slowly move the hair
dryer back and forth so that the tips of the volume diffuser 6 gently massage
your scalp.
■ To cool your hair, you can use the "Cool shot function" (see section Cool shot
function).

Technical data

Mains voltage
Nominal power
Protection class
SHAC 2400 C2
220 – 240 V ∼ (alternating current), 50/60 Hz
2000 – 2400 W
II / (double insulation)
GB │ IE │
7 ■