EINHELL GP-BC 36/430 Li P BL Originalbetriebsanleitung Seite 25

1. (Fig. 10a) Hook the carabiner (Item 20a) into
the strap holder (Item 4).
2. (Fig. 10b) Slip the harness (Item 20) over your
shoulder.
3. (Fig. 11) The harness is equipped with a
buckle. Press the hooks together if you need
to put down the tool quickly.
4. (Fig. 12) Set the length of the harness in such
a way that the cutting head runs parallel to
the ground. To establish the optimum length
of the harness, you should then make a few
swinging movements without starting the
equipment.
5.9 Fitting the battery (Fig. 13)
Push the rechargeable batteries into the battery
mounts provided on the left and right of the tool
(Fig. 2/Item 1). When the battery is pushed in
fully it will engage audibly. To remove the battery,
press the pushlock button (Item K) and pull out
the battery.
Important!
Use only batteries which are charged to the same
level. Never combine full and half-full batteries.
Always charge the two batteries simultaneously.
The machine's operating time depends on the
battery with the lower charge level. The two batte-
ries must always be fully charged before use.
5.10 Charging the battery (Fig. 14)
1. Take the battery pack out of the equipment.
Do this by pressing the pushlock button.
2. Check that your mains voltage is the same as
that marked on the rating plate of the battery
charger. Insert the power plug of the charger
into the socket outlet. The green LED will then
begin to fl ash.
3. Insert the battery pack into the charger.
4. In the section entitled „Charger indicator" you
will fi nd a table with an explanation of the LED
indicator on the charger.
The battery pack can become a little warm during
the charging. This is normal.
If the battery pack fails to charge, check:
•
whether there is voltage at the socket outlet
•
whether there is good contact at the charging
contacts
If the battery pack still fails to charge, send
•
the charging unit
•
and the battery pack
to our customer service center.
Anl_GP-BC_36-430_Li_P_BL_SPK13.indb 25
GB
To ensure that the battery pack provides long
service, you should take care to recharge it
promptly. You must recharge the battery pack
when you notice that the power of the cordless
grass trimmer drops. Never allow the battery pack
to become fully discharged. This will cause it to
develop a defect.
To ensure that items are properly packaged
and delivered when you send them to us,
please contact our customer service or the
point of sale at which the equipment was
purchased.
When shipping or disposing of batteries and
cordless tools, always ensure that they are
packed individually in plastic bags to prevent
short circuits and fi res.
5.11 Battery capacity indicator (Fig. 15)
Press the button for the battery capacity indicator
(Item H). The battery capacity indicator (Item F)
shows the charge status of the battery using 3
LEDs.
All 3 LEDs are lit:
The battery is fully charged.
2 or 1 LED(s) are lit:
The battery has an adequate remaining charge.
1 LED blinks:
The battery is empty, recharge the battery.
All LEDs blink:
The battery temperature is too low. Remove the
battery from the equipment, keep it at room tem-
perature for one day. If the fault reoccurs, this me-
ans that the rechargeable battery has undergone
exhaustive discharge and is defective. Remove
the battery from the equipment. Never use or
charge a defective battery.
6. Operation
Please note that the statutory regulations gover-
ning noise abatement may diff er from one loca-
tion to another.
Danger! The guard hood must be fi tted when
carrying out work.
- 25 -
27.06.2024 10:05:49