Accepting Calls; Troubleshooting - Conrad 92 20 17 Bedienungsanleitung

Accepting calls

Switch on the headset using the on/off button (standby mode)! The green LED flashes. When you recei-
ve a call, you can hear the ringing tone of your telephone or a beep in the headphone. The green LED
now flashes more quickly.
Now press the on/off button again. The LED now lights up permanently. You have now accepted the call
and can speak to the caller over the microphone and hear him/her on the headset. You can go around 30
metres away from the base station (only indoors).
If you press the on/off button slightly to the right or left, you can set the volume correspondingly (louder
or softer). When the conversation has been finished, press the on/off button again. The headset is now
in standby mode.

Troubleshooting

With this headset, you have purchased a product the design of which complies with state-of-the-art.
However, problems and malfunctions can occur. Therefore we should like to explain some possibilities to
you as to how you can eliminate possible faults.
Observe the safety instructions for this also!
Fault
No connection bet-
ween the headset
and base station
Headset cannot be
switched on.
No charging display
16
Possible cause
Connection not successful
The PIN code of the base
station is incorrect.
The accumulator is too low.
Telephone is not GAP-
conform.
Headset has not been used
for a longer period; the
accumulator could be flat.
Solution
Plug in the headset again and
make sure that the distance
between the headset and the
base station is not longer
than 30 metres!
See the operating instruc-
tions of the base station and
alter the PIN code to "0 0 0 0"!
Charge headset!
Charge accumulator!