Preparation And Set Up; Set Up; Inserting Cartridge; Replacing Print Head Gasket - Reiner speed-i-Marker 940 Bedienungsanleitung

speed-i-Marker 940 speed-i-Marker 940

1. Preparation and Set Up

1.1 Set Up

The rechargeable batteries must be completely charged before using the stamp
for the first time. This takes about three hours.
Inserting the rechargeable batteries
Open the rechargeable battery compartment
Be careful to insert the rechargeable batteries the correct way round (+/- polarity).
Close the rechargeable battery compartment
Charging the rechargeable batteries
Connect the device at the USB port
unit and plug it into the mains.
– or –
Connect the device with the PC using a USB cable. You may observe the charging
process in the PCset GRAPHIC software at the charge indicator in the lower right corner.
To do this, the PC must be turned on.

1.2 Inserting cartridge

Turn selector wheel
Push the cartridge cover release key
to open cartridge cover
Take the cartridge out of its packaging and remove protective film from the jet.
Insert the cartridge.
Close the cartridge cover

1.3 Replacing print head gasket

In addition to normal ink, there is also MP ink for metal and plastic surfaces.
For this ink, you need the blue gasket.
Open the cartridge cover
remove the cartridge.
Press and lock the print head shutter lever.
5
Loosen and remove the print head gasket with a pencil.
Install the new print head gasket.
Insert the MP cartridge.
7
7
using a USB cable to the plug-in power supply
8
to Off position.
downwards,
.
.
and
in the direction of the arrow.
.
35