TP-Link CPE210 Installationsanleitung Seite 10

English
Mount the mounting bracket to the
preferred position in the wall� Push and
slide the device to lock it into place� Then
connect the antennas to the device�
■ Mounting the Device on an Antenna (for WBS)
Mount the device on the antenna with
mounting bracket� Connect the RF cables
from the device to the corresponding
connectors on the antenna� Attach the
protective cap�
Software Configurations
■ Managed Mode
To configure mass devices via a centralized management software or a wireless
controller, please refer to the corresponding User Guide� You can download the
User Guide from our website http://www.tp-link.com�
■ Standalone Mode
To configure a device through a web-based management system, please follow the
steps below�
1. Launch a web browser and enter the IP address of your device in the address
bar and press Enter�
Note:
• For EAP, you can check the IP address through your router.
• For other products, the default IP address is 192.168.0.254 and the IP address of your
computer should be set as 192.168.0.x ("x" is any number from 1 to 253).
2. Enter admin for both User Name and Password for login�
3. Change the default User Name and Password to protect your device, then start
configuring the device.
8