Set-Up And Operation - Eurom Heat Plug-In 700 Gebrauchsanleitung

2. Always switch the device off, remove the device from the socket and let the device cool
down before you:
- clean the device
- users maintain the device.
- touch or move the device.
3. Never switch the device on if you have noticed damage to the device itself or if it does
not work properly, makes strange noises, smells odd or you can see smoke, or if it has
fallen or shows any other signs of damage. Remove the device from the socket
immediately. Take the entire device back to your supplier or a recognized electrician to
be checked and/or repaired. Always ask for original parts to be used.
4. The device may only be opened and/or repaired by a competent and qualified person.
Do not carry our your own repairs as this could be dangerous! Repairs carried out by
unauthorised persons or changes made to the device could damage the
dust/waterproof capacity of the device and will nullify the guarantee and the
manufacturer's liability.
Failing to adhere to points 3 and 4 could lead to damage, fire and/or personal injury. They
will invalidate the guarantee and the supplier, importer and/or manufacturer shall not be
liable for the consequences.
Description
1. Blower grid, front
2. PTC element
3. Extraction grid back
4. Plug
5. Operation panel
6. Main switch
7. Display
Location and connection
• Remove all packaging material and keep out of reach of children. After removing the
packaging, check the appliance for damage or other signs of a fault/defect/malfunction.
In case of doubt, do not use the appliance and contact your vendor for inspection or
replacement.
• Select a suitable location for the device taking into account all the
aforementioned warnings in this manual.

Set-up and operation

• Make sure the heater is switched off (on / off switch on off) and then insert the plug into
a correctly working 220-240V~50Hz socket. Note: place the heater with the control panel
facing up.
• Press the on / off switch on the side in the display shows --.
22