Maytronics Classic 4 UNI Gebrauchsanweisung Seite 7

5.2. Putting the Pool Cleaner into the pool
If your Pool Cleaner is equipped with brushes
that contain sponges,dip the brushesin the
water and squeeze them so that they will
absorb water the first time you use the
Pool Cleaner, or if the brushes have dried
out between uses.
Holding the Pool Cleaner upside down in
the water, gently rock it back and forth with
your fingers holding the plastic doors on
the bottom lid open to release trapped air.
Continue until no more bubbles
Release the Pool Cleaner
floor of the pool.
Make surethat the floating cable is free of any
obstructions.
To avoid kinks in the floating cable, place
approximately enough cable in the water for
the Pool Cleaner to reach the farthest corner of
the pool.
ON
Robotic Pool Cleaner Classic 4 / Top 4 - UNI
are released.
and let it sink to the
Sanny
User Instructions
o
o
Turn the power supply ON.
The Pool Cleaner will now operate until it has
reachedthe end of the cleaning cycle.
o
0800 0
5