Maytronics Classic 4 UNI Gebrauchsanweisung Seite 13

8. TROUBLESHOOTING
If the suggest solutions do not solvethe problem contact your dealer
Symptom
1. Cable twisting
or cablecoilsup • Excess c ablein thepool
2. The Pool Cleaner • Dirt stuck in moving parts
is moving in
circles
3. The Pool Cleaner
does not cover
the entire pool
4. The Pool Cleaner
doesnot climb
walls
5. Motors
not working
6. The Pool Cleaner • Air caught in filter bag/cartridge
will not sink
7. Power supply
or power supply
switch light is
not working
Robotic Pool Cleaner Classic 4 / Top 4 -
Possible reason
• Obstruction in pool
• Filter bag/cartridge dirty
• In all abovementioned cases
• Clogged filter bag/cartridge
• Power supply incorrectly
positioned
• Incorrect mounting of bottom lid
• Algae or pool water is out of Spec
• Power supply incorrectly
positioned
• The handle is not positioned
in accordance to the pool
conditions
• Filter bag/cartridge is full
• Algaeon walls
• Water temperature too low
• Brushes worn
• Slippery ceramic wall tiles
• Debris caught around impeller
• The Pool Cleaner istoo light -
trapped air
• Unsuitable pH level
• Impeller blocked
• Drive system blocked
• Electrical problem - motor unit,
cable or power supply
• Special combined climbing
brushes are dry
• Not plugged properly or
non -functioning socket
User Instructions
UNI
Corrective action
• Removeobstruction in pool.
• Removeexcess cable out of the pool.
• Clean filter bag/cartridge.
• Straighten cable and lay in sun periodically.
• Removedirt from moving parts.
• Clean filter bag/cartridge.
• Place power supply in a position so that the
Pool Cleaner can reach all walls.
• Lock bottom lid in the right position.
• Correct pool and water conditions.
• Place power supply in a position so that
the Pool Cleaner can reach all walls.
• You may enhance the pool coverage by adjusting
the handle float. For optimal pool coverage the
Pool Cleaner should turn on the floor at 900 angle
(the Pool Cleaner rotates twice before completing
the 900 turn).
1. If the Pool Cleaner does not complete a 900turn,
shift the float opposite to the cable's entry—side
towards the handle center.
2. Ifthe Pool Cleanerturns in an angle wider than 900,
shift the float on the cable's entry-side towards
the handle center.
• Empty and wash filter bag/cartridge.
• Brush walls.
• Idealwater temperature between 60-340C/430-930E
• Replace brushes - contact your dealer.
• Consult with your dealer about special brushes.
• Remove impeller tube. Clean impeller
• Turn the Pool Cleaner upside down under water
to remove trapped air.
• Check pH level between 7 and 7.8.
• Remove impeller tube and clean impeller.
• Clean tracks and wheels.
• Consult with your dealer and Service Center.
• Turn the Pool Cleaner upside-down under
water to remove trapped air.Washthe filter bag/
cartridge.
• Open two inlet flaps in the bottom lid to remove
dirt and/or trapped air.
• Soak brushes in water.
• Check power to the socket and reconnect
the Pool Cleaner
11