Test Code Entry - BEHA UNITEST 1325 Bedienungsanleitung

9.2 Test Code Entry

Turn function selection dial to "Auto" position (2).
Press the "ENTER" key.
Press the "Scan" key (3) at the barcode scanner
and keep it depressed.
For barcode scanning, point the barcode scan-
ner directly onto the barcode to be scanned or
approach the barcode scanner to the barcode
until an acoustic signal is audible.
The barcode scanner signalises the scanning
of a barcode by emitting an acoustic confirma-
tion sound. The control display (2) briefly lights
at the same time.
The direction of barcode scanning is not im-
portant. However, it is of utmost importance
that the barcode is completely scanned, from
the start to the end. If the entry is incorrect,
please press the "CE" key and then, repeat the
scanning procedure.
Please also refer to the operation manual of the
MACHINEmaster.
If you wish to scan barcodes exceeding a length
of 6 characters, all characters are read and
transferred.
However, the scanning routine of the MACHI-
NEmaster only accepts the last 6 characters
and shows these test code.
You may only use barcodes containing digits.
When inadvertently scanning barcodes contai-
ning alphanumerical characters, the data can-
not be further processed within the MACHINE-
master. To allow further data scanning, switch
the MACHINEmaster off and on again.
Test Code Entry/ Maintenance
Figure 2: Example for UUT number
987654321
Figure 3: Example for UUT number
9.0 Maintenance
When using the instrument in compliance with the
instruction manual, no special maintenance is re-
quired.
9.1 Cleaning
If the instrument is dirty after daily usage, it is ad-
vised to clean it by using a humid cloth and a mild
household detergent. Never use acid detergents or
dissolvants for cleaning. After cleaning, do not use
the voltage tester for a period of approx. 5 hours.
23