Working On The Device; Service Notes - Laserworld Proline Bedienungsanleitung

Manual: Laserworld PRO-400G
10. If the device has been exposed to great
temperature changes, do not switch it
on immediately. Condensation (or any
moisture/water formed) may damage
this device.
11. Never use dimmer, RC or other elect-
ronically switched sockets. Whenever
possible, do not use the laser projector
together with large appliances (espe-
cially fog machines) on the same mains!

4. Working on the device

1. This product has no user serviceable parts inside and should only
be maintained and serviced by a qualified engineer.
2. Be sure that the mains plug is not connected to the power
supply while installing or opening the device (e.g. for
cleaning).
3. Take off all reflecting things like rings, watches etc.
before starting to work with or at the projector.
4. Only use non-reflecting tools to work on device.
5. Wear protective clothing (like goggles, gloves etc.) according to laser power and wave-
length of the laser.

5. Service notes

• Moisture and heat can reduce lifetime of
the laser system dramatically and expires
any warranty claim.
• Quick on/off switching of this device will
reduce durability of the laser diode dra-
matically.
• Avoid sharp knocks and shocks to this
device and ensure sufficient protection
during transportation. Look after your La-
serworld product.
• To increase durability of your laser,
protect device against overheating:
page 5 / 34
12. Ensure sufficient ventilation and do not
place the device on any warm or heat ra-
diating surface. Especially the ventilati-
on openings must not be covered!
13. Ensure that device does not get over-
heated. Make sure that the device is not
exposed to spotlights (especially moving
heads). Heat of spotlights could overheat
laser in a little while and leads to a degra-
dation of performance.
14. This unit is intended for indoor use only.
• Always ensure sufficient ventilation.
• Do not face spotlights (especially mo-
ving heads) to the device.
• Check temperature after approx. 30
minutes with each new installation. If
necessary install the projector at a place
with different temperature.
• Keep the device dry. Protect it from
moisture, rain and damp.
• Switch off device when it is not needed.
Diodes are switched on and can wear out
even if there is no visible laser output.