BRAYER BR1078 Bedienungsanleitung Seite 9

- when the water temperature is from 70 to 79 °С, the
illumination color changes to dark blue;
- when the water temperature is from 80 to 89 °С, the
illumination color changes to yellow;
- when the water temperature is from 90 to 99 °С, the
illumination color changes to purple;
- when the water temperature reaches 100°С, the
illumination will light up red.
• If it is necessary to switch the kettle off, press the On/Off
button (10) « ».
Notes:
- if no actions are performed within 1 minute, the kettle
will pass into standby mode;
- after water boiling, droplets may appear on the
surface of the stand (7) due to steam condensation.
This is a normal phenomenon and is not a warranty
case;
HEATING THE WATER UP TO THE SET
TEMPERATURE/SWITCHING THE WATER
TEMPERATURE MAINTENANCE FUNCTION ON
• You can warm up water up to the required temperature.
For making different tea varieties the special water
temperature is required.
• Recommended water temperature: 40-60°C – for baby
food and other needs, 70°C – white and green tea,
80°C – instant coffee, 90-100°C – black tea.
Notes: the water heating mode is not active when the
temperature is set to 100°C and is used only for boiling of
water.
• In standby mode, press the temperature mode setting
button (9) « » shortly, set the required water heating
mode to 40-70-80-90-100 °C, the digital symbols (12)
and the illumination (11) will show the temperature to
which the water in the kettle flask (1) will be heated.
• If it is necessary to switch the water temperature
maintenance mode on, after setting the water
temperature, press the temperature mode setting button
(9) « » again and hold it for 2 seconds, the water
temperature maintenance function will be switched
on and the water temperature will be maintained for 2
hours.
Note:
- if in the temperature maintenance mode, the water
temperature goes down below the set temperature by
5 degrees, the heating element will be switched on,
the water will heat up to the set value and the heating
function will be switched on for another 2 hours.
- To switch the water temperature maintenance
function on, press the on/off button (10) « », the
water temperature maintenance function will be
switched off.
Note: the memory function is switched on in the water
temperature maintenance mode, if you removed the kettle
from the base (7) 10 times and the water temperature did
not go down by 8 degrees below the set temperature, the
water temperature maintenance function will be active, if
the water temperature goes down by more than 8 degrees
from the set temperature, then the water temperature
maintenance function will be switched off.
EN 9