Alarm Signal - Dorr HA-150 Bedienungsanleitung

07.3 ALARM SIGNAL

When a motion detector registered a movement, the corresponding LED indicator fl ashes green. For example: motion detector
2 registers a movement = LED 2 at the signal indicator (2) fl ashes and the receiver will send out a 15-second sound and vibration
alarm.
07.4 ADJUSTING THE VOLUME/EARPHONES
The volume of sound alarm can be regulated or turned o completely by turning the volume controller (5) on the top of receiver.
Optionally you can use earphones. In this case connect the earphones (optional) to the earphones socket (4).
CAUTION A too loud volume can damage your hearing when using earphones!
07.5 VIBRATION ALARM
The vibration alarm is always active and cannot be regulated.
08 | ORIENTATION/MOUNTING OF RECEIVER AND MOTION DETECTORS
08.1 MOTION DETECTORS
The maximum detecting range of PIR sensor is up to 12m and 90° in an open environment. To avoid false alarm, kindly note that
no fl uttering leaves/branches etc. are near to the motion detectors.
For an optimum detection of objects, we recommend to mount the motion detectors in a height of min. 0,3m – max. 2,00m above
the ground (e.g. to a tree).
The higher you mount the motion detectors, the lower the detection range.
Best results can be achieved with a mounting height of about 0,8m.
To mount the motion detectors, use the supplied mounting straps. Alternatively you can screw on the motion sensors through
the mounting jack (16).
08.2 RECEIVER
With the belt clip (9) the receiver can be attached to the belt or clothing.
Alternatively the receiver should be placed protected from rain within a distance of max. 150m to the motion detectors.
MOTION
DETECTOR
14
RECEIVER