JOYTECH DET-1015 Bedienungsanleitung Seite 6

How to use your thermometer
Guidelines with Illustrations
To measure ear temperature:
1. DET-1015 must be used with the probe protection cover. If the probe
protection cover is not installed, the display will display CAP (as shown
in Figure). To reduce the risk of cross-contamination, it is recommended
to use a new and clean probe cover for each measurement.
2. When the probe protective cover symbol only displays the symbol,
it means that you are preparing to use the probe protective cover
for measurement (as shown in Figure 2). When the display symbol is
flashing from left to right, it means that you are not using the probe
protective cover for measurement (such as Figure 3).
Figure 2
3. Insert the probe along the ear canal as deep as possible into the ear
as depicted in Figure 3. Then press the Test BUTTON once to start the
measurement. A long beep will sound approximately 1 second after the
Test BUTTON is activated. This signals the end of the process as results
are displayed on the LCD screen.
4. The thermometer is ready for testing again once an ear mark
displays on the LCD. A waiting period of 20 seconds between tests is
recommended to avoid excessive cooling of the skin.
5. The thermometer will shut off automatically after 60 seconds of
inactivity. To prolong battery life, press"
8
Figure 1
Figure 3
"Button to turn the unit off.
After measurement:
1. Power off:
- Device will automatically shut off if left idle for more than 1 minute to
extend battery life.
- Press " " Button to turn it off .
2. Clean the probe after each use to ensure an accurate reading and
avoid cross contamination. (See the section of Care and Cleaning for
details.)
BackLight:
In Ear mode:
1. The display will light up GREEN for 3 seconds with a happy face
" " when the unit is ready for measurement and a measurement is
completed with a reading less than 37.3°C(99.1°F).
2. The display will light up YELLOW for 3 seconds with a happy face
" " when a measurement is completed with a reading less than
37.8°C(100.0°F).
3. The display will light up RED for 3 seconds with a bad face "
a measurement is completed with a reading equal to or higher than
37.8°C(100.0°F).
Memory Mode
1. The Memory Mode can be accessed in ear mode:
When the thermometer has been turned on and followed by Figure 2
or finished testing, press and hold the "
The letter "MEM" will appear at the bottom of the display. (See Figure 5)
2. The thermometer will automatically memorize the last 30
temperature readings. Each memory also records the measurement
date/time/mode icon. Each time the "
displays past readings that correspond with a number 1-30. The
number 1 reflects the most recent reading, while the number 30 reveals
the oldest reading stored in memory.(See Figure 6)
3. In the memory mode, " " mark will not change. The user can press
the Test Button to take new measurements.
X
Figure 4
" Button for three seconds.
" Button is pressed, the screen
EN
" when
9