whisker Litter-Robot 4 Bedienungsanleitung Seite 133

Reinstalling the Globe
1.
Place the Globe on the Base in the approximate Home position. Holding the Globe
by the handle and sliding it back into the Base will align it approximately in the
Home position.
2.
Ensure the back of the Globe is sitting flush in the rear bearing pocket and the gear
track is engaged to the motor pinion.
3.
Rotate the Bonnet downward with light pressure on the sides such that the Bonnet
hugs the Globe. This will help to ensure proper alignment of the Bonnet latches to the
Base. Push down on the Bonnet from the top and make sure the Bonnet has latched
into place and the Bonnet is secure.
Note: The unit will not run without the Bonnet installed.
33
www.whiskersupport.com