Sensors And Functions - whisker Litter-Robot 4 Bedienungsanleitung

Litter-Robot Sensors and Functions
Cat Sensor - Curtain Sensor
The Litter-Robot is equipped with Curtain Sensors looking downward across the unit opening
and into the Globe that detect when a cat enters or exits the Globe while in the Home
position. If a Curtain Sensor is activated during a cycle, the Globe will stop. After 15 seconds
of no further activation, the Globe rotation will resume. If your unit is not cycling, please
check the Bezel for any debris (cat fur, dust, etc.) that may be interfering with the Curtain
Sensors. To correct, please wipe the Bezel and Curtain Sensor holes with a dry towel.
Cat Sensor - Weight Scale
The Litter-Robot is equipped with Weight Sensors located in the base of the unit that are
used to further detect and weigh the cat within the Globe while in the Home position. If
additional weight is detected during a cycle, the Globe will stop. After 15 seconds of the
additional weight exiting, the Globe rotation will resume.
Note that each time the unit is powered ON or at the completion of a Clean cycle, the
Weight Sensors measure the weight of the unit to use as a baseline, or "zero." The Weight
Scale can be "zeroed" at any time by pressing the Reset button.
Press the Reset button to zero the Weight Scale after doing anything that affects the unit's
weight. Press Reset firmly and quickly, then watch for the blue Light Bar to flash to confirm
you have zeroed the Weight Scale. Be careful not to rest on the unit as you press the button
or your weight will influence the reading. For best accuracy of the weight scale, the unit
should be placed on a hard, level surface. If placed on carpeting, the accuracy of the scale
will be reduced.
Cat Sensor 1
21
Curtain
Sensors
www.whiskersupport.com
Cat Sensor 2
Weight
Scale