Herunterladen Inhalt Inhalt Diese Seite drucken

Stadler Form Lukas Gebrauchsanweisung Seite 9

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 12
• By pressing the night mode button once more, you can go back into
normal mode.
Note: In night mode (dimmed mode), the dehumidification level is au-
tomatically set on level 1. However, the dehumidification level can be
changed manually by pressing the „SPEED" button (7).
10. Press the Wi-Fi button (11) for 3 seconds to connect Lukas to the
„Stadler Form" App or the „Smart Life – Smart Living" App from Tuya
Inc. (available in the App Store and via Google Play) on your smartphone.
If the device is in pairing mode, the LED above the Wi-Fi button (11)
flashes. If the LED above the Wi-Fi button is illuminated continuously,
this indicates that there is an existing connection between Lukas and
your smartphone. You can control all the functions of the appliance via
the app and monitor the air quality in real time, even when you are not
at home. More detailed information on connecting the device to your
smartphone can be found in the enclosed „Wi-Fi – Quick Setup Guide"
or on our website: www.stadlerform.com/connect.
11. Child lock function: When switched on, all functions can be locked by
pressing and holding (for 3 seconds) the „TIMER" button (10). «CL» (for
„child lock") lights up briefly in the display. In „DRY" mode, the current
humidity is then displayed. In „TIMER" and „LAUNDRY" mode, the dis-
play shows the remaining operating time. If the device is disconnected
from the mains and switched on again, you have to activate the child
lock function again. To deactivate the function, press the „TIMER" but-
ton again for 3 seconds.
12. When the water tank (18) is full, the LED above the „TANK FULL" display
(12) appliance lights up. The dehumidifier switches off automatically.
Please empty the water tank. When you reinsert it, the dehumidifier will
automatically switch back on.
13. If desired, it is possible to connect a drainage hose to the unit for per-
manent water drainage. In this case connect the hose (13) to the unit
through the hole in the back of the dehumidifier and place the end of
the drainage in a water outlet. Please make sure the end of the hose is
lower than the spout, otherwise the water will not drain and flooding
may occur.
14. For easy side movement of the unit there are hidden wheels (22) at-
tached. First, empty the tank completely. Now you can easily move the
dehumidifier to the desired location.
15. If the device is not used on a daily basis, switch it off by pressing the On/
Off button (4) and empty the water tank. Note: The device has a memory
function and saves the last selected setting when you switch off the
device and disconnect it from the power supply.
Replacement of the HEPA filter (optional accessory)
Lukas can optionally be equipped with a HEPA filter, which also cleans
particles from the air. The HEPA filter (17) cannot be cleaned and must be
replaced after approx. 12 months. To replace the filter, switch off the device
and remove the air inlet filter (15) on the back. Remove the HEPA filter (17)
and insert the new filter. Then reattach the air inlet grid. The HEPA filter can
be obtained from the dealer where you purchased your Lukas.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis