Werbung
Verfügbare Sprachen
Verfügbare Sprachen
11. Troubleshooting
Any trouble occurring might be due to a minor
problem that you can correct yourself follow-
ing the instructions below. Do not try any fur-
ther action if the pointers given cannot solve
the problem!
Repairs on the cabinet must be made only by
qualified specialists. Incompetent repair work
can cause serious personal danger, contract
your Service Organization for any repairs
needed.
Trouble
The cabinet does
not work (no audi-
ble running noise or
only fan noise audi-
ble.)
Cabinet stops run-
ning after short op-
eration
Storage tempera-
ture is too high.
Storage tempera-
ture is too low.
Formation of odor
in the cabinet.
Condensation on
the sliding glass lids.
Possible cause
Automatic evaporator defrosting ac-
tive or electronic controller
switched off.
Power plug not connected or re-
mote control switch (where pro-
vided) switched off. Fuse blown,
power plug or socket defective.
Condenser fins fouled
Condenser fins fouled.
Automatic evaporator defrosting ac-
tive.
Ambient temperature too high or
electronic controller misadjusted.
The warm air outlet or another cabi-
net is directly taken in as air intake.
Ventilation slots blocked or cov-
ered. Lack of air intake due to ob-
struction of air intake grill.
Condenser fins fouled.
Incorrect adjustment
Drip water gutter under base plate
fouled.
Wrong close of the sliding lids.
Corrective measures
Nor required, as cooling will switch on auto-
matically again.
Insert power plug properly in or switch remote
control switch on.
Contact your electrician or the Service Organi-
zation.
Perform maintenance.
Perform maintenance.
Not required, temporary minor temperature
rise during defrosting is normal.
Avoid extreme operating environment, readjust
storage temperature.
Observe single-row line-
up and group installation.
Keep ventilation slots free.
Remove any obstacles in the air intake area.
Perform maintenance.
Adjust storage temperature in small
increments.
Clean
Close the lids properly.
Werbung
