Werbung
Verfügbare Sprachen
Verfügbare Sprachen
8. Product Loading
8.1 Loading the cabinet with prod-
ucts
•
As soon as the cabinet has reached the
prescribed storage temperature (see
section 6), it can be loaded with products.
•
The time required to reach the pre-
scribed storage temperature after the
start of the operation depends on the
ambient temperature. It is reached ap-
proximately 1 hour after it has started.
•
Check the storage temperature at the
thermometer. (Fig.1-1)
•
Load the cabinet with items up to max. of
the load limit lines. (Fig.2)
•
OTC95, STP1309 Do not charge the re-
frigerator with products that are not re-
frigerated or use it to cool products.
•
OTC95, STP1309 Do not load the cabinet
with unfrozen products or try to freeze
products in the cabinet. Only products
with a temperature of -18 ° C or lower
can be loaded into the cabinet. An excep-
tion to this is formed by the types OTC95
and STP1309 if the cabinets have been
switched to temperature range 2. In this
case the double temperature cabinet
may only be charged with products that
have a product temperature of + 5 ° C or
lower.
•
The cabinet must not be loaded above
the load boundary lines to ensure that it
works correctly and that frozen products
can be presented at a safe temperature.
9. Automatic evap-
orator defrosting
•
Defrosting of the evaporator fins and
evaporation of the drip water formed
during defrosting is performed automat-
ically.
•
During automatic defrosting, the tem-
perature in the display compartment
may rise slightly.
•
Defrost frequency as well as duration
and time are factory-set. Defrosting of
the case is carried out automatically. For
this reason, intervention in the case is
not necessary. The drip water formed is
automatically evaporated via the waste
heat of the refrigeration system.
•
The cabinet possesses a maintenance-
free, electronic defrost timer with a run-
ning reserve for bridging times without a
supply of current.
•
The defrost timer has been set to the cor-
rect time in the factory. Alterations of
the programming can only be done by
the Service Organization, as the operat-
ing behavior of the cabinet can be al-
tered by improper operation.
Werbung
