Werbung
Verfügbare Sprachen
Verfügbare Sprachen
product temperatures for the different
product groups with regard to the stor-
age of food in refrigerated and frozen
food cabinets:
Dairy products
Cold drinks
Frozen food, ice cream
When setting the temperature set point,
please note that changes in ambient condi-
tions demand a corresponding adaptation of
the set temperature
7.2 Thermostat: setting:
Factory thermostat setting:
Type
Preset
OTC95BE
Position 6
OTF87BE
Position 6
STP1309
Position 6
•
Position 7 marks the coldest tempera-
ture setting in both thermostats. We rec-
ommend making the new setting in small
increments, since the cabinet needs time
to adjust to the new temperature setting.
•
Should a readjustment or reset of the
storage temperature be required:
-
Turn the setting knob (2-1) to a
higher or lower temperature to cor-
rect the storage temperature.
-
Use the thermometer to check the
storage temperature.
7.3 Setting for the electronic
controller
•
The controller has been pre-set in the
factory and works automatically. The
basic setting has been pre-set to ambient
air conditions of 25°C and 60% rel. hu-
midity
•
Should a readjustment or reset of the
storage temperature be required:
•
When setting the temperature, please
observe the following:
-
Changes in the ambient conditions
demand
+10 °or colder
+5 ° C or colder
-18 °or colder
a
corresponding
adaptation of the temperature.
-
Only carry out the temperature
changes in small steps, as a certain
time must elapse before the re-
quired storage temperatures are
reached.
-
After the set key is pressed, > 2 sec,
the figure displayed on the control
electronics is no longer the storage
temperature but temperature set
point. The storage temperature is
only shown again when the temper-
ature set point has been set. (Fig.3).
Lower the storage temperature:
•
Press the key (Fig.4-1) until the tempera-
ture is lowered to the required figure.
•
Press the set key in order to store the
new temperature (Fig.3).
Raising the storage temperature:
•
Press the button (Fig.4-2) until the tem-
perature is raised to the desired figure.
•
Press the setting button to store the new
temperature (see fig.3).
•
A number of additional parameters can
be set on the temperature control. How-
ever, modification of these parameters
should only be done by authorized ser-
vice personnel, as it affects the operating
performance of the refrigerator.
•
The setpoint temperature is factory set.
If the temperature displayed on the con-
troller approx. 4 hours after the products
are loaded into the cabinet is not be-
tween value temperatures, the tempera-
ture can be readjusted.
•
Should readjustment or resetting of the
storage temperature be required, see
section 6.
Werbung
