EchoNous Kosmos Power Pack Kurzanleitung Seite 4

Setting up your Power Pack
Step 1: Make sure Power Pack is charged for one hour prior to use.
(See instructions on Charging your Power Pack).
Step 2: Position Power Pack onto device
so that it sits comfortably in hand when
in use, keeping both port to device and
Power Pack are on the same side.
Depending on the size of the tablet, the
Power Pack may need to shift to the left
or right to get a comfortable it.
Step 3: Once the Power Pack position
is set to your preference, peel o the
adhesive backing on each strip and
place the Power Pack onto the device in
desired position. Press irmly onto the
Power Pack and hold for 45 seconds to
make sure adhesive is applied tightly to
the device.
Notes:
– Adhesive strips are not for reuse.
– The adhesive will not adhere to rubber.
Step 4: Connect the Power Pack cable
to the tablet as shown
A: Power Pack cable
B: Probe cable connection
Note: Power Pack must be connected to
the tablet first in order for the probe to be
recognized by the Power Pack.
4 Americ n English
A
A
B
Desired position
WARNING: Read instructions before placing Power Pack on
the tablet for the best user experience
WARNING: Read instructions before placing Power Pack on
the tablet for the best user experience
B