Safety Warnings; General Warnings - Kemper 1500KIT Bedienungsanleitung

Thank you for purchasing one of our products. We recommend you carefully read this instruction manual: it contains
important information regarding safety regulations for use and maintenance of the appliance. It is also recommended to
keep this document carefully to consult in case of necessity.
1. This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance in a
safe way and understand the hazards involved. Children shall not play
with the appliance. Cleaning and user maintenance shall not be made
by children without supervision.
2. CAUTION: This tool must be placed on its stand when not in use.
Keep the tool away from flammable materials (curtains, combustible
material, furniture, etc.).
3. To use this appliance in total safety implies observing some basic
safety measures, such as: never use the appliance with wet hands or
feet, never expose the appliance to moisture or water, never leave the
appliance exposed to atmospheric agents, never disconnect the plug
by pulling the power cord or the appliance itself.
4. After finishing the work, turn off the product and leave the soldering
iron cool in the air; never put it under water in order to avoid electric
shocks. Do not touch metal parts of the soldering iron (tips or
resistances) when it is on, with your hands or other parts of the body.
High temperatures can cause severe burns.
5. This tool can set fire to different materials, make a proof on a
discarded material before use.
6. If the power cord is damaged, it must be replaced by the
manufacturer or the manufacturer's technical support service, or by an
adequately qualified technician so as to prevent any risks. The power
cord must never be in contact with the hot surfaces of the soldering iron.
7. This tool is not a toy.
8. ATTENTION: Always place the stand on a flat and regular surface.
1. Before using the tool, control its integrity, if there are any defective parts, or it has other conditions, which could
negatively influence its functions and safety. Remove all the packaging material and make sure that the appliance is
in good condition. If you have any doubt, do not use the appliance and contact our After-Sales Service. Keep the
packaging material (staples, nylon bags, etc.) out of the reach of children.
2. Before plugging the soldering iron into a socket, check whether your voltage corresponds to the rating label of the
appliance. This appliance must be connected to an approved mains socket that complies with the safety regulations
on electrical systems for civil purposes. The electrical system must be specific for the appliance rated voltage. Never
cover the appliance, as this could cause risk of overheating.
3. Do not leave the soldering iron on, if you do not use it; it causes an early oxidation reaching over-temperatures which
could compromise the duration of the resistances.
4. The appliance must be used only for its intended use, that is soldering iron. Any other use than its intended purpose
shall be deemed to be improper and hazardous. The manufacturer shall not be held responsible for damages derived
from misuse of this appliance.
5. Always unplug the appliance before performing any maintenance and whether it is not used for long periods of time.
6. Before inserting or removing the tips, unplug the appliance. Never connect the power cord to extensions or triple
plugs. Do not pull or damage the power cord. If the appliance does not work properly, immediately turn off the
appliance and disconnect it from the mains socket. For repairs, contact a technical support centre authorised by the
DT ISTR (1500KIT) 11/2010_REV 11_06/20

SAFETY WARNINGS

GENERAL WARNINGS

6/36