Whispbar K987W Montageanleitung Seite 9

EN
Fitting Kit
K987W
Unhook rubber ditch mould from plastic
retaining clip (A) and double sided tape (B).
Lift ditch mould up and out of the channel.
Completely remove from the vehicle.
The rubber ditch mould is to be re-installed
on the vehicle later.
Unhook rubber ditch mould from plastic
retaining clip (A) and double sided tape (B).
Lift ditch mould up and out of the channel.
Completely remove from the vehicle.
The rubber ditch mould is to be re-installed
on the vehicle later.
Line up the centre hole in the mounting
block with the marked reference points.
Wrap tape around rubber ditch mould to
mark end position of mount.
9