Led Indicator - Tenda Rx2 Pro Schnellinstallationsanleitung

LED indicator

LED indicator Scenario
Startup
Internet connection
LED indicator
WPS
Ethernet cable connection
PPPoE user name and password importing
Resetting
Jack, ports and buttons
Jack/Port/Button Description
Gigabit LAN/IPTV port.
IPTV/3
It is a LAN port by default. When the IPTV function is enabled, it can only serve as an IPTV port to connect to a set-top box.
Gigabit LAN port.
1, 2
Used to connect to such devices as computers, switches and game machines.
Gigabit WAN port.
WAN
Used to connect to a modem or the Ethernet jack for internet access.
Used to start the WPS negotiation process, or to reset the router.
- WPS: Through the WPS negotiation, you can connect to the WiFi network of the router without entering the password.
Method: Press the button, and the LED indicator blinks green fast. Within 2 minutes, enable the WPS function of the other WPS-supported device to
WPS/RST
establish a WPS connection.
- Reset: When the router is working normally, hold the button down for about 8 seconds, and then release it when the LED indicator blinks orange fast.
The router is reset.
POWER Power jack.
06
Status
Solid green
Solid green
Blinking green slowly
Blinking red slowly
Blinking orange slowly
Blinking green quickly
Blinking green quickly for 3 seconds
Blinking green quickly for 8 seconds
Blinking orange quickly
Description
Starting up
Connected to the internet
Not configured and not connected to the internet
Configured but internet connection failed
Configured but no Ethernet cable is connected to the WAN port
Pending for or performing WPS negotiation(valid within 2 minutes)
Device connected to or disconnected from an Ethernet port of the router
PPPoE user name and password imported successfully
Resetting