Switching Off The Device; Special Faults - Cooper WSM 1 Betriebsanleitung

Note:
The power units have been adapted to hold a medium-
sized soldering tip. Discrepancies may occur if the tip is
changed or a different shaped tip is used, but these can be
overcome using the offset function.

6.3 Switching off the device

Press the + and – button until "OFF" appears on the
display
Note
If you do not intend to use the soldering iron for longer
periods, set the disconnecting switch to "O".
Make sure that the battery is charged at least 50 %, see
Information on the application note for battery on page 8.
Soldering tip change
Caution, risk of burning!
Tools are not required to change the soldering tip.
Only change a cold soldering tip.
The soldering tip is inserted in handle (24) and can be
removed by simply pulling the soft grip on the soldering tip
(25).
Important
- Change the soldering tip when cold.
- Always ensure that the soldering tip is seated properly.
6.4 Switching the temperature unit
Switching the temperature unit from "°C to °F" (8) or vice
versa.
1. Select the menu item "°C / °F" in the menu.
2. Set the temperature unit with the - or + button.
3. The display reverts to the normal temperature
if no buttons are pressed for about 2 seconds.
The stem is fitted with a sensor that monitors device use,
i.e. when the stem is inserted in the rest, the temperature
is reduced to standby temperature after 5 minutes and
switched off after 5 more minutes.
7. Special functions for
WSM 1 / WSM 1C
after 3 s without pressing button
Actual value
display
Preset SETBACK
+ and -
TIME after
5 min of disuse
Preset standby
2 s
temperature
200 °C
4 s
Preset OFF-
SET TIME after
5 min of disuse
6 s
OFF
8 s
OFF
10 s
12 s
14 s
Setting the standby temperature
The following standby temperatures are available
(150 °C – 250 °C / 300 °F – 480 °F).
1. Select the "STANDBY" (18) menu item in the menu.
2. Set the setpoint value for the standby temperature with
the - or + button.
3. The display reverts to the normal temperature
if no buttons are pressed for about 3 seconds.
Setting the automatic switch-off time (AUTO-OFF)
The following AUTO-OFF time settings (17) are available:
- "10 – 60 min." AUTO-OFF time, individually adjustable
1. Select the menu item "OFF" in the menu.
Setpoint value
+ or -
display
OFF
STANDBY
AUTO OFF
OFF SET
SETBACK
°C / °F
LOCK
English
OFF
10