Werbung
Verfügbare Sprachen
Verfügbare Sprachen
When working on metal under extreme working condi-
tions conductive dust deposits can occur inside the cut-
ter motor, thereby impairing the protective insulation of
the tool. In such cases the use of a stationary vacuuming
system, frequent blowing out of the ventilation slots and
protection by a fault current protection switch are advised.
4.1.2 c
hAnging the cArBOn Brushes
The cutter motor is equipped with two carbon brushes.
The carbon brushes must be changed as follows:
Loosen the screw and remove the cover.
Raise the spring (1), and remove the carbon brushes
(2). Clean the carbon brush holders. Insert new carbon
brushes. It is imperative that the brushes are arranged
in the correct order. Replace the cover and tighten the
screws.
4.2 s
pAre pArts
See page 2-3.
4.3 r
epAir
If the cutter motor strict observance of the manufacturing
and testing method the tool should happen to fail, it must
be repaired by an authorized SUHNER agency.
Any replacement needed for the connecting line must be
installed by the manufacturer or its agent if safety risks are
to be eliminated.
4.4 w
ArrAnty
In the event of the tool being improperly handled, used
for purposes for which it is not intended and/or of the ser-
vice and maintenance instructions not being observed by
non-authorized persons, no warranty shall be in effect for
16
damages/consequential damages. Complaints can only
be honored if the cutter motor is returned in the undisas-
sembled condition.
4.5 s
tOrAge
Temperature range: -15°C to +50°C
Max. relative air humidity: 90% at +30°C, 65% at +50°C
4.6 d
/ e
ispOsAl
nVirOnmentAl cOmpAtiBility
This cutter machine consists of materials which can be
disposed of in a recycling process.
Before disposal, render the cutter machine unusable.
Do not throw the cutter machine into the garbage
collection.
According to national regulations this cutter ma-
chine must be recycled in an environmentally-friendly
manner.
Werbung
