OPERATION - General information
The below description goes with the image on page 2.
1.
On-/Off switch with indicator light
2.
Infinitely adjustable temperature knob
3.
Temperature-light (top and bottom heat)
4.
Lid
5.
Handle
6.
Baking plates
7.
Cable and plug
1.
Unpack the device and remove all packaging parts.
2.
Clean the baking plates to remove any residues that may be left from the manufacturing process (see
"Cleaning and maintenance"). Dry them thoroughly.
3.
This appliance must be connected to an earthed socket.
PLEASE NOTE:
•
The first time you use the appliance, it may produce slight smoke and a specific odour. This is normal
and will disappear on its own. Ensure sufficient ventilation.
•
Keep birds away from the appliance when the appliance is in operation. When heating the non-stick
coating on the baking tray, a substance can be released that is a nuisance to birds.
Use of pizza oven
1.
Insert the plug (7) into the wall socket and switch on the oven with the On/Off switch (1).
2.
Open the lid (4) with the handle (5).
3.
Clean the oven (see 'Cleaning and maintenance').
4.
Close the lid.
5.
Turn the temperature knob (2) to the desired position. The Temperature-light (3) will be switched on.
6.
After warming up (approx. 7 minutes), the Temperature-light will switch off and the oven is ready to use.
7.
Open the lid.
8.
Place the pizza or other food in the oven.
9.
Close the lid. Prepare delicious frozen and fresh pizza (Ø 27cm) in about 10 minutes.
10. Remove the pizza or other food from the oven when it is ready.
PLEASE NOTE:
•
Please note that while using the appliance the Temperature-lights turn on and off occasionally. This is
normal and gives an indication that the automatic thermostat keeps the oven to the set temperature.
•
Please note that you can also use the oven to prepare meals. The preparation times depend on the
type of food and the quantity. Preferably use a lower temperature setting than with baking of pizzas.
As table grill
You can also use this device as a table grill. Follow these steps:
1.
Open the device and fold open
2.
Allow the appliance to preheat
3.
Place the food you want to grill, on the grill plate.
4.
Place the food you want to heat in the deep tray.
5.
Take the food and place them on a plate. Careful! The food is hot.
CLEANING AND MAINTENANCE
1.
Remove the plug from the wall socket, and allow the appliance to cool.
2.
Clean the exterior of the appliance with a damp cloth, and dry with a clean cloth. Make sure no
moisture gets into the appliance.
WARNING:
•
Never use corrosive or scouring cleaning agents or sharp objects (such as knives or hard brushes) to
clean the appliance.
14
14
EN
EN