Balluff BOS01EY Betriebsanleitung Seite 5

BOS 18M
Photoelectric Sensors – Infrared light diffuse reflective
User's Guide
Safety Notes
These photoelectric sensors may not be used in
applications where personal safety depends on
proper function of the devices (not safety
designed per EU machine guideline). Read
these operating instructions carefully before
putting the device into service.
The CE Marking confirms that our products
conform to the EU Directives (EMC) and the
EMC Law.
In our EMC Laboratory, which is accredited by
the DATech for Testing of Electromagnetic
Compatibility, proof has been documented that
these Balluff products meet the EMC
requirements of the harmonized standard
IEC 60947-5-2.
Wiring diagrams
Fig. 1: Wiring diagram, pinouts
english
1
Order Code Diffuse reflective
BOS01EY BOS 18M-PA-ID20-S4
BOS01EZ BOS 18M-NA-ID20-S4
BOS01HL BOS 18M-PS-ID23-S4
BOS01TZ BOS 18M-PS-ID25-S4
– Optical filter for greatest possible ambient light rejection
– Function reserve indicator for high operating reliability
– Strong light sources for very long ranges
– Rugged housing
– No irritation by light beam
Installation
The sensor must be installed as to prevent a direct line of
eyesight to the radiation source, even during operation.
For operation no further precautions are required (exempt
group acc. EN 62471).
BOS 18M-...-ID20
BOS 18M-...-ID23/25
Fig. 2:
PNP
N.O.-N.C,
Pins 4-2
NPN
PNP
N.O., Pin 4
PNP
Infrared radiation.
Dimensions
Sensing range
800 mm
800 mm
600 mm
100 mm
Receiver
Emitter
LED green
LED yellow
LED green
LED yellow