Introduction / Scope Of Supply; Introduction / Transport An Storage - BEHA 0113 Bedienungsanleitung

Introduction / Transport an Storage

Contents
1.0 Introduction / Scope of Supply ..................10
2.0 Transport an Storage ................................10
3.0 Operator's Safety ......................................11
4.0 Operation Elements and Connections ........12
5.0 Carrying out Measurements ......................13
5.1 Preparation and Safety Measures ..............13
5.2 Voltage Tests in Compliance with
DIN VDE 0113 / EN 60204..........................14
6.0 Maintenance ..............................................14
6.1 Cleaning ....................................................15
6.2 Fuse Replacement......................................15
6.3 Calibration Intervall ....................................15
7.0 Technical Data ..........................................15
References marked on instrument or in
instruction manual:
Warning of a potential danger, comply with in-
struction manual.
Reference. Please use utmost attention.
Caution! Dangerous voltage. Danger of electri-
cal shock.
Continuous double or reinforced insulation
complies with category II.
Conformity symbol, the instrument complies
with the valid directives. It complies with the
EMC Directive (89/336/EEC), Standards EN
50081-1and EN 50082-1 are fulfilled. It also
complies with the Low Voltage Directive
(73/23/EEC), Standard EN 61010-1 is fulfilled.
The instruction manual contains information
and references, necessary for safe opera-
tion and maintenance of the instrument.
Prior to using the instrument (commissioning
/assembly) the user is kindly requested to thor-
oughly read the instruction manual and com-
ply with it in all sections.
Failure to read the instruction manual or to
comply with the warnings and references
contained herein can result in serious bodi-
ly injury or instrument damage.
10
page
1.0 Introduction
You have purchased a high quality measurement in-
strument of Ch. BEHA GmbH which will allow you
to carry out reproducible measurements over a long
time period. The company Ch. BEHA GmbH is a
member of the world-wide operating BEHA Group
with its head office in Glottertal/Schwarzwald which
also houses the technological centre. The BEHA
Group is a leading manufacturer of Test and Mea-
surement Instruments.
UNITEST High Voltage Tester 0113 is an instrument
for acceptance of electrical equipment of machines,
switch cabinets, switchboard plants, and instru-
ment in compliance with DIN VDE 0113 / EN 60204
and BGV A2 VBG 4.
Scope of Supply:
1 pc High Voltage Tester Cat. No. 9030
1 pc Holster
1 pc Instruction manual
2 pcs High voltage measurement leads
2.0 Transport and Storage
Please keep the original packaging for later trans-
port, e.g. for calibration. Any transport damage due
to faulty packaging will be excluded from warranty
claims.
In order to avoid instrument damage, it is advised
to remove accumulators when not using the instru-
ment over a certain time period. However, should
the instrument be contaminated by leaking battery
cells, you are kindly requested to return it to the fac-
tory for cleaning and inspection.
Instruments must be stored in dry and closed areas.
In the case of an instrument being transported in ex-
treme temperatures, a recovery time of minimum 2
hours is required prior to instrument operation.