Wolf 762 mm Installationsanweisungen Seite 9

Gas Range Installation
Oven Door Removal
IMPORTANT NOTE: Remove the oven door(s) only if it is
necessary to fit the range through a tight doorway.
Removal may cause damage to the porcelain oven interior
or the door(s). Door removal should be done by a qualified
service technician or installer.
For removal, a hinge pin (supplied with the range) must be
inserted in the appropriate hinge arm. For each oven door,
only one hinge arm is spring loaded, requiring use of the
hinge pin for removal of the oven door. The hinge pin can
be found taped to the inside of the oven door.
For single oven ranges, the hinge pin will be inserted
through the hole in the right hinge arm (facing the range).
For double oven ranges, the spring hinges are located on
the outer edges of the unit. The left oven door will have
the spring hinge on the left side and the right oven door
will have the spring hinge on the right side. Refer to the
illustrations below.
Failure to insert the hinge pin in the appropriate hinge
arm will cause damage to the range.
SPRING HINGE
SPRING HINGES
Single oven gas ranges. Double oven gas ranges.
OVEN DOOR REMOVAL
1) Open the oven door all the way and insert the door
hinge pin through the hole in the appropriate hinge
arm. Refer to the illustration below.
2) Remove both upper and lower hinge retainer mounting
screws. The oven gasket may have to be moved
slightly to access the bottom screws.
3) Move the hinge retainer plate forward slightly. The
hinge retainer plate will remain on the door hinge after
the mounting screws have been removed.
4) Carefully close the oven door to approximately 60°
from horizontal and lift the door away from the oven.
A slight racking motion may be required for removal.
5) For double oven ranges, complete these steps for both
oven doors.
Do not lift or carry the oven door by the door handle.
HINGE
RETAINER UPPER
PLATE MOUNTING
SCREW
HINGE
PIN
KICKPLATE
Oven door removal.
REINSTALL OVEN DOOR
1) Hold the oven door on both sides and position it with
door hinges aligned with openings in the oven frame.
2) Holding the oven door approximately 30° from vertical,
slide the hinges into the openings until the bottom
hinge arms drop fully into the receptacles.
3) Open the oven door all the way and remove the hinge
pin from the hinge arm.
4) Reinstall the hinge retainer plate with upper and lower
mounting screws.
5) Open and close the door completely to ensure that it is
properly installed.
6) For double oven ranges, complete these steps for both
oven doors.
Level the Range
IMPORTANT NOTE: The top of the range must be level.
Use both the adjustable front legs and the adjustable rear
casters to level the range.
The front legs of the range are adjusted by rotating the
bottom hexagonal portion of the leg. The rear casters can
be adjusted by rotating the nut on the caster. Using the
height adjustment wrench (supplied with the range), rotate
the nut clockwise to raise the range or counterclockwise
to lower. Refer to the illustration below. The range legs and
casters allow for a 25 mm height adjustment.
CASTER
ADJUSTMENT
HEIGHT
ADJUSTMENT
WRENCH
Rear caster adjustment.
10