Technical Specifications - FOLLO FUTURA STABILIS Bedienungsanleitung

FOLLO STABILIS EL.TILT
Congratulations on choosing a Follo Stabilis product. This manual enables you to take full
advantage of the product from the first day in use. Please read these instructions carefully
before faking the product into use. Contents:
- How to use

- Technical specifications

- Safety information
HOW TO TRAIN:
The EI-tilt is used for training to an upright position. Choose an angle so that the patient can
exercise comfortably. Note the angle each session. Try all the functions on a colleague
before the EI-tilt is used on a patient.
SAFETY INSTRUCTIONS:
1. Ensure that nothing gets entangled in the moving parts while the product is used.
Be sure that the Velcro is in proper condition and that the belt can be properly
fastened.
2. Describe to the patient what the exercise comprises before the treatment.
3. Make slow process with small angular deflections. Keep eye contact with the
patient at all times.
HOW TO USE:
1. The patient may lay down on the bench when it is horizontal. Make sure that the
sole of the foot is in contact with the foot plate.
Strap on the belts. There are three belts: Two small for the torso and hip, and one
large to knees.
2. Adjust for the back rest to a comfortable position. Tilt the bench slowly upwards
and adjust the belt if necessary. Check that the feets are resting on the footplate.
Tighten or loos the Velcro as necessary.
3. The table can be assembled now if wanted. The table can not be used instead of
the upper fastening belt.
4. The angle of the footplate can be adjusted while the bench in a upright position.
You can raise and lower the bench also in the upright position. The battery back up
enables you to operate the tilt table not being connected to a main power
- Maintenance instructions
- Spare parts list
Follo Futura AS, Brekkeveien 43, N-1430 Ås
MAINTENANCE INSTRUCTIONS:
Check the following at regular intervals (every third month):
1. First clean then lubricate moving parts often by using a little Vaseline oil.
2. Freeplay in such things as straps and handles should be adjusted immediately to
avoid further wear and tear.
3. Change worn fixing screws etc. to ensure the equipment functions satisfactorily.
EXTRA EQUIPMENT:
Large foot plate
TECHNICAL SPECIFICATIONS:
Min/max height
Tilt angle
Foot plate
Back rest
Four 24V Linak motors
Weight:
Length:
Width:
IMPORTANT:
AFTER UNPACKING, THE BATTERIES SHOULD BE CHARGED FOR AT LEAST 12
HOURS USING A GROUNDED, 23OV OR 11 OV SOCKET. IT IS RECOMMENDED THAT
THE BATTERIES BE RECHARGED OVERNIGHT IF A MAINS POWER SUPPLY IS NOT
USED. THE ELECTRICAL PLUG MAY REMAIN IN THE SOCKET WITHOUT HARMING
THE BATTERIES.
QUICK RELEASE TILT FUNCTION:
USE THE HANDGRIP AT THE REAR OF THE BENCH, AND TURN THE HANDLE
WHICH IS ATTACHED TO THE TILT MOTOR. THE TILT FUNCTION CAN BE MOVED BY
HAND. RELEASE THE HANDLE AND THE TILT FUNCTION AUTOMATICALLY LOCKS.
NORWAY
55-93cm
0°-80°
-20°-+5°
0°-30°
Maximum load 170kg
112 kg
197cm
70cm
14/08/18
Side 9
Rev: 25