Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OPTIONS
- If the selected option is not compatible with the set wash cycle, the
indicator light will flash and the option will not be activated.
Stain removal
This option allows for selecting the type of dirt so as to optimally adjust the
cycle for removing the stains. The following types of dirt can be selected:
Food, for stains caused by foodstuffs and beverages, for example.
-
Work, for grease and ink stains, for example.
-
Outdoor, for mud and grass stains, for example
-
! The wash cycle duration varies according to the type of selected dirt.
Delayed Start
- (
)
To set a delayed start for the selected cycle, press the corresponding
button repeatedly until the desired delay period has been reached. When
this option has been activated, the
remove the delayed start setting, press the button until the word "OFF"
appears on the display.
Temperature
- ( )
Each wash cycle has a pre-defined temperature. To modify the
temperature, press the
button. The value will appear on the display.
Spin
Each wash cycle has a pre-defined spin speed. To modify the spin speed,
press the
button. The value will appear on the display.
Setting the drying cycle
The first time the button
is pressed, the machine will automatically
select the maximum drying cycle which is compatible with the selected
wash cycle. Subsequent presses will decrease the drying level and then the
drying time, until the cycle is excluded completely ("OFF").
Drying may be set as follows:
A- Based on the desired laundry dryness level:
Cupboard
: suitable for laundry which can be put back in a cupboard
without being ironed.
Hanger
: ideal for clothes which do not need to be dried fully.
Iron
: suitable for clothes which will need ironing afterwards. the
remaining dampness softens creases, making them easier to remove.
B - Based on a set time period: between 210 and 30 minutes.
If your laundry load to be washed and dried is much greater than the
maximum stated load (see adjacent table of wash cycles), perform the
wash cycle, and when the cycle is complete, divide the garments into
groups and put some of them back in the drum. At this point, follow the
instructions provided for a "Drying only" cycle. Repeat this procedure for
the remainder of the load. Note: a cooling-down period is always added to
the end of each drying cycle.
Drying only
Press button
to perform the drying-only cycle. After selecting the
desired cycle (compatible with the type of garments), press button
exclude the washing phase and start the drying phase at the maximum
level for the selected cycle. The drying level or time may be set and
changed by pressing the drying button
(Not compatible with cycle 13).
PUSH & GO
To start the Push&Go cycle press and hold the button for 2 seconds.
The indicator lights up to show that the cycle has started. The wash and
drying cycle is ideal for cotton or synthetic fabrics, as it washes them at a
temperature of 30° and a maximum spin speed of 1000 rpm.
During the drying cycle the maximum temperature is 60°C. At the end of
the cycle the residual humidity will be the same as for the "
recommended load 3 kg.
The time displayed is the maximum time allowed by the Push&Go cycle.
If the load is lower than the maximum load or most garment are made of
synthetic materials, the actual time of the cycle will be shorter.
How does it work?
1. Load the laundry (cotton and/or synthetic garments) and close the door.
2. Pour the detergent and/or additives.
3. Start the cycle by pressing and holding the Push&Go button for 2
seconds. The relevant indicator light will turn green and the door will lock
(the DOOR LOCKED symbol is lit).
NB: starting the cycle through the Push&Go button activates an
automatic non-customisable wash and drying cycle recommended for
cotton and synthetic fabrics.
4. The automatic cycle can be used only for washing, excluding the drying
phase. Press the Push&Go button and then the drying button
drying icon of the "
" level will switch off. Maximum load for washing-only
is 3 kg. The cycle cannot be customised further.
To open the door while an automatic cycle is under way, press the START/
PAUSE button. If the DOOR LOCKED symbol is off, the door may be opened
only during the washing phase. Press the START/PAUSE button again to
restart the wash cycle from the point at which it was interrupted.
5. At the end of the wash cycle the word END will light up.
TIPS AND SUGGESTIONS
Divide the laundry according to:
Type of fabric (cotton, mixed fibres, synthetics, wool, garments to be
hand-washed). Colour (separate coloured garments from whites, wash new
coloured garments separately). Delicates (small garments – such as nylon
stockings – and items with hooks – such as bras: insert them in a fabric bag).
Empty the pockets:
Objects such as coins or lighters can damage the washer-dryer and the
drum. Check all buttons.
Follow the dosage recommendation / additives
It optimizes the cleaning result, it avoids irritating residues of surplus detergent
in your laundry and it saves money by avoiding waste of surplus detergent.
symbol lights up on the display. To
.
" level. Max
: the
Use low temperature and longer duration
The most efficient programmes in terms of energy consumption are
generally those that perform at lower temperatures and longer duration.
Observe the load sizes
Load your washing machine up to the capacity indicated in the
"Wash Cycle Table" table to save water and energy.
Noise and remaining moisture content
They are influenced by the spinning speed: the higher the spinning speed
in the spinning phase, the higher the noise and the lower the remaining
moisture content.
CARE AND MAINTENANCE
Before performing cleaning and maintenance, switch the washer-dryer off
and disconnect it from the mains power. Do not use flammable liquids to
clean the washer-dryer. Clean and maintain your washer-dryer periodically
(at least 4 times per year).
Disconnect the water and power supplies
Close the water tap after every wash. This will limit wear on the hydraulic
system inside the washer-dryer and help to prevent leaks. Unplug the
washer-dryer when cleaning it and during all maintenance work.
Clean the washer-dryer
The outer parts and rubber components of the appliance can be cleaned
using a soft cloth soaked in lukewarm soapy water. Do not use solvents or
abrasives. The washer-dryer has a "Auto-clean"
parts; it must be run without any load in the drum.
To optimise this cycle, it is possible to use either detergent (10% of the
quantity specified for lightly soiled garments) or special additives to clean
the washer-dryer. We recommend running a cleaning cycle every 40 wash
cycles. To start the cycle press buttons
seconds. The cycle will start automatically and will run for about 70
minutes. To stop the cycle, press the START/PAUSE
Clean the detergent dispenser drawer
Wash it under running water; this operation should be repeated frequently.
Care for the door and drum
Always leave the porthole door ajar in order to prevent unpleasant odours
from forming.
Clean the pump
The washer-dryer is fitted with a auto-cleaning pump that does not require any
maintenance. Small items (such as coins or buttons) may sometimes fall into
the protective pre-chamber situated at the base of the pump.
! Make sure the wash cycle has ended and unplug the appliance.
To access the pre-chamber:
1. remove the cover panel on the front of the machine by first pressing it
in the centre then pushing downwards on both sides to extract it;
2. loosen the drainage pump cover by turning it anti-clockwise: it is
normal for some water to leak out;
3. clean the inside thoroughly;
4. screw the cover back on;
to
5. put the panel back in place, making sure the hooks slot in place before
pushing the panel onto the appliance.
Check the water inlet hose
Check the water inlet hose at least once a year. If it is cracked or broken, it
must be replaced: during wash cycles, the high pressure of the water
could suddenly split the hose open.
! Never use hoses that have already been used.
LOAD BALANCING SYSTEM
Before every spin cycle, to avoid excessive vibrations before every
spin and to distribute the load in a uniform manner, the drum rotates
continuously at a speed which is slightly greater than the washing
rotation speed. If, after several attempts, the load is not balanced
correctly, the machine spins at a reduced spin speed. If the load is
excessively unbalanced, the washer-dryer performs the distribution
process instead of spinning. To encourage improved load distribution and
balance, we recommend small and large garments are mixed in the load.
ACCESSORIES
Contact our Technical Assistance Service to check whether the following
accessories are available for this washer-dryer model.
Stacking kit
With this accessory you can secure the tumble dryer to the upper part of
your washer-dryer to save space and facilitate loading and unloading of
the tumble dryer.
TRANSPORT AND HANDLING
Do not lift the washer-dryer by gripping it from the upper section.
Unplug the appliance and close the water tap. Check that the door and
detergent dispenser drawer are tightly closed. Detach the filling hose
from the water tap then detach the drain hose. Empty all the water
remaining in the hoses and secure the latter so that they do not get
damaged during transport. Apply the transport bolts back on. Repeat, in
reverse order, the transport bolt removal procedure described in the
"Health & Safety and Installation Guides".
cycle for its internal
and
simultaneously for 5
button.
Werbung
