Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CLEANING THE DETERGENT DISPENSER
Remove the dispenser by raising it and pulling it out (see figure).
Wash it under running water; this operation should be repeated frequently.
1a
1
A
2
1b
1
B
2
CLEANING THE WATER FILTER / DRAINING RESIDUAL WATER
Switch off and unplug the washer- dryer before cleaning the water filter or draining residual water. If you used a hot
wash programme, wait until the water has cooled down before draining any water.
Clean the water filter regularly every 3 months, to avoid that the water cannot drain after the wash due to obstruction of the filter.
If the water cannot drain, the display indicates that the water filter may be clogged.
1.
Remove the kick panel: Using a screwdriver, do that which
is shown in the following figure.
2.
Container for the drained water:
Place a low and wide container under the water filter in
order to collect the residual water.
3.
Drain the water:
Slowly turn the filter counter-clockwise until all the water
has come out. Allow the water to flow out without
removing the filter. Once the container is full, close the
water filter by turning it clockwise. Empty the container.
Repeat the procedure until all the water has been drained.
2a
2b
4.
Remove filter: Lay a cotton cloth beneath the water filter,
which can absorb a small amount of rest water. Then
remove the water filter by turning it out anticlockwise.
5.
Clean the water filter: remove residues in the filter and
clean it under running water.
6.
Insert the water filter and reinstall the plinth: Reinsert the water
filter again by turning it in clockwise direction. Make sure to turn
it in as far as it goes; the filter handle must be in vertical position.
To test water tightness of the water filter, you can pour about 1
liter of water into the detergent dispenser. Then reinstall the
plinth.
3a
3b
2
1
4a
2
1
4b
Werbung
