Axis Communications P1468-XLE Installationsanleitung Seite 8

AXIS P1468-XLE Explosion-Protected Bullet Camera
(防 防 防 爆 爆 爆 型 型 型 弾 弾 弾 丸 丸 丸 カ カ カ メ メ メ ラ ラ ラ )
IECEx certificate number
Degree of protection according to EN/IEC
60529
Operating temperature
Material
Cable diameter
Specific conditions of use to be considered for
installation with this device
* The Ingress Protection of the device is not relying on the cable gland. Instead it is provided
by the cable grommets inside the equipment.
Cable gland installation
WARNING
Hazard due to modification or alteration! Explosion protection at risk!
The cable gland may not be modified or altered.
Before installation:
• Ensure that the cable gland is undamaged. Check the thread, sealing rings and
o-ring-sealings.
• Remove the dust cap.
• Additional reliable strain relief/anchorage must be guaranteed for the inserted and
fixed installed cables.
During installation:
• Make sure that the cable gland is fully screwed into the connecting thread.
• Ensure proper seating of the sealing rings and o-ring-sealings.
• Ensure that the specified protection grades are upheld.
• To prevent loosening, if necessary use an additional hexagonal locknut or suitable thread
locking fluid.
IECEx BVS 17.0101X
IP66/IP68 (10 bar, 30 min)*
-40 °C to +85 °C
Nickel plated brass
Nitrile rubber NBR
8–13 mm
The cable gland is tested with a reduced tensile
force (25%) in accordance with clause A.3.1
of IEC 60079-0. It may only be used for fixed
installation of Group II and Group III apparatus.
The user shall ensure adequate clamping of
the cable.
8