Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6.
HOW TO SET UP THE SENSOR
6.1 LCD DISPLAY
To turn on the LCD display, press any button except the reset
button (
) and it will turn on.
The display will stay on for 30 seconds before turning off.
6.2 HOW TO SET THE VALUES FOR THE WIND SPEED AT WHICH THE
AWNING IS RETRACTED AND THE LIGHT INTENSITY AT WHICH THE
AWNING IS EXTENDED.
M
01. Press the
button on the sensor for two seconds.
02. The display will show the icon
, yand the value set for the light intensity. The unit of
measurement is Klux, and if this is the first time the sensor is configured, it will start from the
value "0.0".
UP
A
03. Pressing
increases, and pressing
quickly, press and hold the buttons.
M
Pressing the M button again
, the display will show the icon
M
A
maximum wind speed. The unit is Km/h and we recommend setting a value lower than 15 km/h
to protect your awning from any wind gusts that may damage the structure. You can use the
UP
P2
UP
A
and
buttons, as in the previous point, to set the desired value.
04. Once you have selected both values, sun and wind, the settings will be automatically saved.
After approximately 10 seconds, the marked value will stop flashing and will indicate that the
configuration is correct.
6.3 HOW TO CHECK THE SET WIND AND SUN DETECTION VALUES
M
01. Press the
button on the sensor once, the icon
Klux value set to extend the awning will be shown.
M
02. Press the
button a second time, the icon
the maximum wind speed configured to retract the awning.
03. Press the
M
button a third time to return to the normal sensor mode.
UP
14
M
A
UP
P2
decreases the figure. To change the values more
and the value set as the
M
A
UP
P2
will be displayed on the screen, and the
will be displayed on the screen, and shows
M
A
UP
P2
M
A
P2
6.4 HOW TO CHECK THE CURRENT WIND AND LIGHT VALUES ON THE
SCREEN
01. Press the button
A
of the sensor once, the current value measured by the light intensity
sensor will be displayed.
A
02. Press button
a second time, the current value measured by the wind speed sensor will be
displayed.
A
03. Press button
for the third time, the icon will light up on the display, and both light and wind
measured values will be displayed in a loop.
04. Press button
A
for the fourth time, it will return to point 1.
7.
WARRANTY
All components of this product, whether due to a manufacturing defect or breakdown during the
warranty period, will be replaced or repaired, provided that the cause of the incident is not due to misuse
or incorrect installation.
This warranty applies for the establishment where the product was purchased. Please visit the
establishment and take the product with you if you need to use the warranty.
The warranty period for this product varies depending on the legal regulations applied in the country of
purchase. Please refer to the applicable country regulations for more information.
15
M
A
Werbung
