Power On - Artillery Sidewinder X4 Pro Bedienungsanleitung

3.Introduction of the device screen inte爀昀ace

3.3 Power on

When sta爀琀ing the machine for the 昀椀rst time, it enters the boot
1
program. Please follow the prompts on the screen.
1/6
Self-est
Wait for the nozzle temperature to
heat to 210 ° C and sta爀琀 adjusting
the nozzle temperature
Cancel Next step
3/6
In order to ensure the
accuracy of the model, the
system will car爀礀 out manual
leveling
Next step
Place a piece of A4 paper between the nozzle and the hot bed, move
2
the nozzle to 5 points in turn by operating the touch screen, and click
"Next" after completion.
Manual leveling
Point 1 Point 2
Point 3 Point 4
Intermediate point
Next step
09
2/6
Please make sure there is no
sundries on the nozzle
Return Next step
Please wait for the platform and
nozzle position to initialize.
Operate according to the screen inte爀昀ace prompts, and wait for the platform
3
and nozzle position to be initialized.
4/6
In order to ensure the
accuracy of the model, the
system will automatically level Please make sure there is no
sundries on the nozzle
YES Next step NO
Return
Car爀礀 out the "Z=0" o昀昀set step, and adjust the Z axis to move up and down, so
4
that the height from the nozzle to the platform is about the thickness of A4
paper (0.08-0.1 mm), and there is obvious friction feeling when drawing A4
paper. Click next and wait for the automatic leveling step to end.
Move up
0.01 0.05
Move down
0.1 1
Zo昀昀set=0 Z=0
Collecting 81 compensation values, please
Use the Move Up/Move Down key on the right to
adjust the height of the platform so that the leveling
paper has a slight friction between the nozzle and the
platform, and then click the key below.
Save Next step
After the consumables are loaded into the feeding hole and extruded smoothly,
5
click "Next" to inse爀琀 the U disk with printed documents.
5/6
Please inse爀琀 U disk
Load consumables into the feed
hole and obse爀瘀e whether the
tailings are extruded. If not, please
click Load or Check
Load YES Next step NO
Please wait for the platform and
nozzle position to initialize.
Next step
23
wait......
6/6
Finish