Werbung
Verfügbare Sprachen
Verfügbare Sprachen
necklaces, etc.
11). Do not work in uncomfortable positions. Keep
well balanced with firm footing, to avoid falls and
injuries.
12). Take great care when using this equipment. Al-
ways pay attention while working. Carelessness
can cause accidents and injuries. Never use this
equipment when you cannot concentrate properly,
such as when you are tired, under the influence of
alcohol, ill, affected by medication, etc.
13). Do not mishandle the power lead. Do not carry
the unit by the power lead, nor unplug it by pulling
on the lead. Do not leave the power lead close to
hot objects, grease or oil, or near blades or other
objects with sharp edges. Take care not to step on
the cable, and avoid pulling or straining it, to avoid
damage. Failure to observe this precaution could
lead to electric shock or short circuits that could
cause a fire.
14). Inspect the electric power lead and the plug re-
gularly. If they are damaged, ask our local repre-
sentative or distributor to repair it. If an extension
lead is used, this should be inspected periodically
and replaced if it is damaged. If extension leads
are used in the open, they should be suitable for
outdoor use to avoid the risks of electric shock,
short-circuits and fires. Keep the unit's handles,
etc., dry, clean and grease- and oil-free, to ensure
safe handling. If the unit is dropped, this could lead
to injury.
15). When you are not using the equipment, store it
carefully. Keep it locked in a dry place out of the
reach of children.
16). Always ask for assistance from an authorised
KRAISSMANN agent if the equipment must be
disassembled for repair. Our products comply
with applicable safety regulations. Do not mo-
dify them. All repairs should be carried out by
our local representative or distributor. Repairs
carried out by unprofessional or unqualified per-
sonnel could affect the operation of the equip-
ment and could cause accidents or injuries.
DESCRIPTION OF THE EQUIPMENT
The SOCKET WELDER P63-S6 has been designed
to weld tubes and accessories made of PE, PP, PB
and PVDF, both in the workshop and on worksites.
TECHNICAL CHARACTERISTICS
Voltage: 230 V AC
Power/ Current: Nominal power = 2500 W
Frequency: 50/60 Hz
Working range: 75-110 mm
Temperature range: min. 0
PREPARATION FOR USE
This equipment leaves the factory completely
finished and ready to use; it needs no adjustment or
preparation for use.
OPERATING INSTRUCTIONS
Welding with this unit consists of three phases:
• preparing the tube
• preparing the socket welding device
• the welding process
A) PREPARING THE TUBE
Cut the tube straight across using a suitable tool
(pipe cutter or cropper)
C - max. 300
C
o
o
• Clean the surface
to be welded and the
adapters with cellu-
lose tissue dampene
Mark the length of
• Mark the length
of the weld on the
tube
9
Werbung
