Kraissmann 2500EMS3 Gebrauchsanweisung Seite 8

ENGLISH
IMPORTANT
This manual contains information required for
safe use of this equipment.
• Ensure that the user receives a copy of this manual.
• Keep this manual in a location where the operator
can easily consult it whenever necessary.
• Before using the socket welding device, read this
manual carefully and follow the instructions and
advice it contains.
• Take care to comply with the Safety Measures de-
scribed in this manual, to avoid accidents such as
fires, electric shock and other injuries. It is essenti-
al that the personnel that use this equipment read
and understand this manual.
• Ensure that the persons that use this equipment
have the necessary attitudes and aptitudes.
• Do not use the socket welding device in any way
except that described in this instruction manual.
SAFETY PRECAUTIONS
The equipment that you are about to use has
been designed according to the latest techniques
and complies with applicable safety regulations.
Nevertheless, given its nature, its use is poten-
tially dangerous. To avoid accidents, observe the
safety instructions given in this manual.
These safety instructions are indicated in this ma-
nual by the following icons.
⚠ DANGER
Indicates situations that can lead to death or se-
vere injury for the user.
PRECAUTION
Indicates risk situations that can lead to injuries
or damage to property.
NOTE
Indicates advice that can help to produce the best
results, and other information.
• Please pay attention to these warnings, since they
are important for safe use of the equipment.
• If this instruction manual is lost or damaged, re-
quest a replacement immediately from our repre-
sentative.
• Components and specifications are subject to ch-
ange without prior notice, in order to improve the
quality or operation of the equipment or to comply
with safety regulations. In this case, the photogra-
8
ELECTRIC SOCKET WELDER
phs and illustrations, etc., in this manual may not
correspond to the product supplied.
SAFETY ADVICE
⚠ DANGER
1). Ensure that the voltage supply is correct. The cor-
rect voltage is indicated on the name plate of the
main unit or in the instruction manual. If the wrong
voltage is used, this may cause overheating, smo-
ke or fire.
2). The unit should only be connected to the mains
supply and used for welding once the unit is at-
tached to the workbench using the G-Clamp. The
legs of the unit should only be used to handle the
unit when cold until it is held firmly in place with
the G-clamp and connected to the mains supply.
3). Never touch the mains plug with wet hands.
4). Ensure that the unit is installed in a suitable locati-
on. Do not use this equipment in the rain, in damp
or wet locations, or in locations where water could
easily enter the unit. Never use it in the vicinity of
inflammable liquids or gases, such as petrol or tur-
pentine. This could cause fires or explosions.
5). Only use the specified accessories and attach-
ments. Never use accessories or attachments
other than those specified in the instruction ma-
nual or in our catalogue, otherwise, accidents or
injuries could be produced.
6). If any anomaly is detected, such as strange
smells, vibrations or noises, turn the unit off imme-
diately. Do not attempt to disassemble the unit. In
case of problems, contact our local representative
or distributor.
7). Keep the workplace clean and tidy. Ensure that
the workbench and the work area are kept in per-
fect condition and well lit. Untidy work areas or
workbenches cause accidents.
8). Do not allow unauthorised personnel to have ac-
cess to this equipment. Do not allow unauthorised
persons to handle the unit or to have access to the
power lead. Do not allow unauthorised persons
into the workplace, especially children.
9). Do not overload the equipment. Use it only accor-
ding to its design conditions.
10). Use proper clothing. Do not work wearing a tie,
loose or „floppy" clothing, accessories such as
2500EMS3