Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• Maintain the tube and the accessory on the adap-
ters during the time indicated under HEATING TIME
in table 2.
2) Assembly
• Remove the tube and the accessory from
the adapters.
• Without rotating them, introduce the tube into the
accessory until the weld-length mark is reached.
This operation should be carried out as quickly and
carefully as possible, within the time (MAX AS-
SEMBLY TIME) shown in Table 2).
Hold the two parts together during the time indica-
ted under SETTING TIME in Table 2 (page 23).
NOTE
Ensure that the region of the weld is not subjected
to any force during this time.
4) Cooling
• Allow the tube to cool for the time recommended
in Table 2 (COOLING TIME).
After the cooling time has finished, the welded tubes
and accessories can be used as recommended by
the tube manufacturer.
11
Werbung
