Werbung
Verfügbare Sprachen
Verfügbare Sprachen
11. Technische Daten
Co-Location
This transmitter must not be co-located or operated in conjunction with any other
antenna or transmitter.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes :
DE
1. l'appareil ne doit pas produire de brouillage, et
2. l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
Attention
Exposition au rayonnement de radiofréquences Cet équipement est conforme aux
limites d'exposition aux radiofréquences IC fixées pour un environnement non contrôlé
et aux Lignes directrices relatives à l'exposition aux radiofréquences (RF).
Colocation
Ce transmetteur ne peut pas être installé en colocation ou être utilisé avec une autre
antenne ou transmetteur, quel qu'en soit le type.
11.2.2 FCC warnings
Information from the FCC (Federal Communications Commission)
For your own safety
Shielded cables should be used for a composite interface. This is to ensure continued
protection against radio frequency interference.
FCC warning statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
■
Increase the separation between the equipment and receiver.
■
Connect the equipment into an outlet on a circuit different from that to which the
■
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
■
140
WIKA-Betriebsanleitung, Typ CPG1200
Werbung
