Other Functions; Changing The Sound Settings; Adjusting The Sound Characteristics; Customizing The Equalizer Curve - Eq3 Parametric Tune - Sony CDX-GT740UI Bedienungsanleitung

Other functions

Changing the sound settings

Adjusting the sound
characteristics
1
Press the control dial.
2
Rotate the control dial until the
desired menu item appears, then
press it.
Depending on the setting, by rotating the
control dial again, further parameters can be
set.
3
Rotate the control dial to select the
setting, then press it.
4
Press (BACK).
The setting is complete and the display
returns to normal play/reception mode.
The following items can be set:
EQ3 Parametric Preset
Selects an equalizer curve from 7 music types.
EQ3 Parametric Tune*
Custom equalizer settings.
Subwoofer Tune & LPF
Phase
Selects the phase (effective only when LPF is
on): "Normal," "Reverse."
FREQ
Selects the subwoofer cut-off frequency:
"80Hz," "100Hz," "120Hz," "140Hz," "160Hz,"
"OFF."
Level
Adjusts the subwoofer volume: "+10dB" –
"0dB" – "–10dB."
("– ∞" is displayed at the lowest setting.)
HPF & Speaker Select
Speaker
Selects the Speaker: "All," "Front", or "Rear."
FREQ
Selects the cut-off frequency: "OFF," "80Hz,"
"100Hz," "120Hz," "140Hz," "160Hz."
DSO (Dynamic Soundstage Organizer)
Creates a more ambient sound field.
To select the DSO mode: "1," "2," "3," or "off."
The larger the number, the more enhanced the
effect.
Fader & Balance
Fader
Adjusts the relative level: "Front:15"– "Center"
– "Rear:15."
Balance
Adjusts the sound balance: "Right:15"–
"Center" – "Left:15."
1
AUX Level* 2
Adjusts the volume level for each connected
auxiliary equipment: "+18 dB" – "0 dB" – "–8
dB."
This setting negates the need to adjust the
volume level between sources.
*1 Hidden when EQ3 Parametric Preset is set to "off."
*2 When AUX source is activated.
Customizing the equalizer curve
— EQ3 Parametric Tune
"Custom" of EQ3 Parametric Preset allows you
to make your own equalizer settings.
Select "Custom" of EQ3 Parametric Preset.
1
Select a source, then press and hold
the control dial.
2
Rotate the control dial to select "EQ3
Parametric Tune," then press it.
3
Setting the equalizer curve.
You can adjust the equalizer center frequency,
volume level and bandwidth in each range
from "Low," "Mid", or "Hi."
1 Rotate the control dial until the desired
menu item appears, then press it.
2 Rotate the control dial to select the
setting, then press it.
Selectable frequency in each range:
Low: 60 Hz or 100 Hz
Mid: 500 Hz or 1.0 kHz
Hi: 10.0 kHz or 12.5 kHz
60Hz 100Hz 500Hz 1.0kHz
LOW MID
Adjustable volume level: "+10 dB" –
"0 dB" – "–10 dB."
+10dB
0dB
-10dB
continue to next page t
10.0kHz 12.5kHz
HI
19