Replacing The Lamp; Tips For Saving Energy - KKT KOLBE KS1220G Benutzerhandbuch

Operation, care and cleaning

Replacing the lamp

Switch off before the lamp replacement unit and
disconnect the mains plug or switch off fuse, or turn
out.
Lamp data: 220-240V, max. 15W
• To replace the bulb: Unscrew the screw (depending on
model).
• Press the lamp cover and remove the lamp cover to the
rear.
• Replace defective bulbs.
• Refit the lamp cover and tighten screw.
• Switch power on.

Tips for saving energy

• Do not place the appliance near cookers, radiators or other
heat sources. At high ambient temperature, the compres-
sor runs more often and longer and leads to increased
energy consumption.
• Allow adequate ventilation on the unit base and on the rear
side. Vents you should never cover.
• The arrangement of drawers and shelves as they are seen
in the figure, provides the most efficient use of energy and
should therefore be retained as possible.
• All drawers and shelves should remain in the unit to keep
the temperature stable and to conserve energy.
• To get a bigger storage space (eg in a large refrigerated /
frozen food), the middle drawers are removed. The upper
and lower drawers and shelves should be removed if ne-
cessary as a last resort.
• A uniformly filled fridge freezer compartment contributes
to the optimal use of energy. Therefore, avoid empty or
half-empty compartments.
• Allow hot food to cool down before you put them in the
fridge / freezer. Already cooled foods increase energy
efficiency.
• Let frozen in the refrigerator to thaw. The cold of the frozen
food reduces energy consumption in the cooling compart-
ment, thus increasing the energy efficiency.
• Open the door only as short as necessary to minimize the
loss of cold air. Short open and properly closed doors redu-
ce energy demand.
• Setting the temperature not colder than necessary contri-
butes an optimal use of energy. The optimum temperature
in the refrigerator is + 7 ° C. It should be measured in refri-
gerators on the top shelf as far forward.
• Allow adequate ventilation on the unit base, the devices
sides and on the rear panel. Vents you should never cover.
Please also note the distance measures under Chapter,
„setting up".
• Keep the condenser - the metal mesh on the rear side -
always clean.
• A regular cleaning minimizes the energy consumption of
your device (depending on device construction may not be
accessible).
• The door gaskets of your device must be completely intact,
so that the doors close properly and the power consumpti-
on is not increased unnecessarily.
17