Hyundai HHE203203 Benutzerhandbuch Seite 3

B. Also you can change the battery in the main body
directly. The three lights in the top of the body will indicate the state of
the battery. when the battery is fully charged, all three lights will keep
bright in green.
OPERATING THE VACUUM
CAUTION: The vacuum must be fully charged before using for the first
time.
1. Remove the vacuum cleaner from the wall mount.
If using as a hand held unit, disassemble the tube
and attach the desired accessory.
2. Use the Power ON/OFF
button to turn on the appliance.
3. For a stronger suction, press the Power
adjustment key to
increase the strength.
deal for when you are cleaning carpets with a high pile.
4. To turn off the vacuum, press the Power ON/OFF button again.
MAINTAINING THE VACUUM
Cleaning the dust container
1. Press the dust container release button and disassemble the unit so
only the main
body remains.
2. Unclip the dust container from the main body.
3. Over a waste bin, press the dust release button to open the bottom
cover and expel any dust, dirt and debris. Wipe clean only, do not
submerge in water.
CLEANING THE FILTER:
1. Remove the dust container from the main body.
2. Twist the lid of the dust container anit-clockwise to open.
3. Remove the sponge inlet filter from the top of the dust container.
4. Rinse thoroughly under clean fresh water. Do not use soap or other
cleaning agents.
5. Allow filter to dry naturally before placing back into the vacuum. Do
not place on
radiators or use additional appliances, such as a hair dryer, to dry
the filter. Doing so may cause the filter to warp or for other irreparable
damage to occur.
CLEANING THE BRUSH ROLL:
1. Slide the brush roll securing catch "A" away from the brush as
indicated in the illustration below.
2. Remove the brush roll from the brush housing.
3. Carefully clean and remove any hairs and fibres from the brush roll.
Wipe clean only, do not use any soap or harsh cleaning agents.
4. If brush roll becomes damp during cleaning, allow to dry naturally
before replacing the brush roll back into the housing.
5. Slide securing catch "A" back into original position to secure the
brush roll.
TROUBLESHOOTING
The appliance will not power on.
This may be caused by a flat battery. This can occur if the appliance
has been used or stored for an extended period of time. Connect the
vacuum to the charger and allow for a full charging cycle to complete.
The vacuum stopped suddenly:
This will occur if the safety cut-out device has been activated. This
device is designed to prevent your appliance from overheating. Ensure
the vacuum is turned off , disconnect all accessories and leave to cool
down for at least half an hour before attempting to operate again. Try
to identify the source of the overheat by checking for blockages in the
extension tube motor-drived floor head and accessories.
Empty the dust container and clean or replace the filter.
The suction of the vacuum has reduced:
Turn the vacuum off. Disconnect the floor head, extension tube and any
accessories. Check for and remove any blockages from the dustbin
filter, air duct, extension tube
floor head and accessories.