Candy CDSN 2D520PX Bedienungsanleitung Seite 105

DISABLING REMOTE CONTROL
l
To exit remote control, press "Progr. 3sec
WiFi" again for 3 secs.
l
When no cycle is under way:
The Wi-Fi indicator light will start to flash
slowly and the message "REMOTE
CONTROL OFF" will appear on the
display. The display will then show the
last programme
machine (or the "ECO" programme).
l
When a cycle is under way:
The Wi-Fi indicator light will start to flash
slowly and the message "REMOTE
CONTROL OFF" will appear on the
display. The display will then show the
remaining time.
The cycle will be completed without
control from the App.
Alternative way to exit remote control.
l
Press the "Start/Reset" button for 3 secs
If there is a cycle under way, it will be
cancelled, and the machine will exit
REMOTE CONTROL mode.
The "Wi-Fi" indicator light will flash
slowly. It is now possible to set a new
wash cycle from the control panel.
l
Press the "ON/OFF" button for 3 secs
(or power off)
If there is a cycle under way, it will be
paused and the
REMOTE CONTROL mode.
On switching on again, the "Wi-Fi"
indicator light will flash slowly and any
cycle under way will continue from the
point of interruption.
Opening the door,
CONTROL will be disabled. To resume
control from the App, close the door.
completed by the
machine will exit
any REMOTE
"Wi-Fi" indicator light
l
Indicates the connection status of the
product to the home Wi-Fi network. It can
be:
- FIXED ON: remote control enabled.
- SLOW FLASHING:
disabled.
- QUICK FLASHING FOR 3 SECONDS,
THEN OFF:
connect to the home Wi-Fi network or
has not yet been enrolled on the App.
- SLOWLY FLASHING 3 TIMES, THEN
OFF FOR 2 SECONDS: enrolment
procedure on the App in progress.
- ON FOR 1 SECOND, THEN OFF FOR
3 SECONDS: the door is open. Remote
control cannot be enabled.
105
remote control
the machine cannot
.