Using The Software - Renkforce Rf-Hsp-500 Bedienungsanleitung

Next, connect the printer to the USB port of your computer.

7.7 Using the software

Double-click to open the software.
First, select the printer. Select "RF-HSP-500 printer".
Select the size of the heat shrink tubing that you want to print on.
Now you can use the software to edit the data (text, graphics, barcodes, etc.).
Example
In this example we want to print on heat shrink tubing with diameter of 10 mm (17 mm flat) over
a length of 50 mm.
Select the labelling length (50 mm)
To enter text, click on the "A" and then go into the writing area below. Then you can enter
the text required.
The text can be changed to the required size or moved to another position by dragging
the corners.
Then, press the "Print" icon to print your text onto the heat shrink
tubing.
The print dialogue will appear. Press "OK" to go ahead with print-
ing on the heat shrink tubing.
In this example, "Half cut(H)" is selected in settings, which means that the heat shrink tub-
ing will be partly cut. This makes it easier to detach.
8 Troubleshooting
Problem LED Status
No printer found. Yellow LED off.
Casing is open. Red LED on.
Printer does not Red LED on.
start printing.
Error in reading Red LED on.
of the ribbon.
Ribbon empty. Red LED on.
End of heat Red LED on.
shrink tubing
reached.
Under normal conditions, the green and yellow LEDs will always light up after turning on.
3
Reason Solution
The printer is not connected Please check that
correctly. the printer is turned
on, that the USB
The printer will not turn on.
port is connected
The driver is not installed or
correctly and that
is installed incorrectly.
the printer driver
has been installed
correctly.
Casing (cover) is open. Check the casing
fastener.
Casing (cover) is open after Check the casing
trying to start printing. fastener.
The ribbon is not loaded or Replace ribbon
is loaded incorrectly or an or install ribbon
incorrect ribbon is installed. correctly.
End of ribbon reached. Replace ribbon.
Ribbon torn. Repair the torn
ribbon with adhesive.
Printer suddenly turns off
during printing.
End of heat shrink tubing. Replace the heat
shrink tubing.