Hifonics ZEUS EVOLUTION ZXE600/4 Bedienungsanleitung Seite 13

FIGURES
(P. 30-33)
CONNECTIONS AND CONTROLLERS (FIG. 1)
(1) POWER / PROTECT LED
(2) HIGH PASS controller (FRONT)
(3) Selector HP – FULL (FRONT)
(4) LEVEL INPUT controller (FRONT)
(5) LINE INPUT (FL/FR & RL/RR)
(6) LEVEL INPUT controller (REAR)
(7) Selector INPUT MODE 2CH/4CH
(8) HIGH PASS / BAND PASS filter controller (REAR)
(9) Selector FULL – HP – LP/BP (REAR)
(10) LOW PASS / BAND PASS controller (REAR)
(11) BASS BOOST controller (REAR)
(12) Connector for the included bass level remote controller
POWER SUPPLY AND TURN ON CONNECTION (FIG. 2)
(1) GND terminal for the ground
(2) REM terminal for the turn on connection
(3) +12 V terminal for the positive-connection of the battery
(4) Vehicle's battery
(5) External cable fuse for +12V power wire (not included in the scope of delivery)
(6) Turn on wire from the head unit or the electrical antenna
(7) Fuses
4-CHANNEL OPERATION STEREO (FIG. 3)
If you run the amplifier with the 4 line output channels* from the head unit to operate 2 loudspeakers on FRONT
and 2 loudspeakers on REAR in stereo, connect the following setup:
(1) To the head unit, line output left (FL/CH1)
(2) To the head unit, line output right (FR/CH2)
(3) To the head unit, line output left (RL/CH3)
(4) To the head unit, line output right (RR/CH4)
(5) Loudspeaker left (RL)
(6) Loudspeaker right (RR)
(7) Loudspeaker left (FL)
(8) Loudspeaker right (FR)
3-CHANNEL OPERATION STEREO & MONO (FIG. 4)
If you run the amplifier with 4 line output channels* from the head unit to operate 2 loudspeakers in stereo and
1 subwoofer in mono/bridged, connect the following setup:
(1) To the head unit, line output left (FL/CH1)
(2) To the head unit, line output right (FR/CH2)
(3) To the head unit, line output left (RL/CH3) or subwoofer output
(4) To the head unit, line output right (RR/CH4) or subwoofer output
(5) Bass level remote controller
(6) Loudspeaker left (FL)
(7) Loudspeaker right (FR)
(8) Subwoofer (RL- and RR+)
* If your head unit only has two output channels, connect FL and FR and set the switch INPUT MODE to posi-
tion 2CH.
13