Hifonics ZEUS EVOLUTION ZXE600/4 Bedienungsanleitung Seite 10

Please read the user's manual carefully before the installation and the first operation of the amplifier.
SPECIFICATIONS
Output Power RMS (14.4 V)
Loudspeaker impedance (stereo)
Frequency response
Total harmonic distortion
Signal-to-noise ratio
Input sensitivity
Input impedance
Highpass filter (FRONT)
Highpass filter/Bandpass filter (REAR)
Lowpass filter/Bandpass filter (REAR)
Bass Boost (REAR)
Pre-amplifier inputs
High level inputs
Auto turn-on
Operating voltage
Fuse rating
Dimensions (B x H x L)
All specifications are subject to change
IMPORTANT NOTES PRIOR TO INSTALLATION
- This device is only suited for a 12 volt system with negative ground.
- The radiated heat while operation requires sufficient air circulation at the place of installation. It is
very important that the heat sink fins do not have contact with any metal parts or any surfaces which
could impair air circulation. The amplifier may not be installed in small closed location or spaces
without air circulation (e.g. spare wheel recess or below the vehicle carpeting). We recommend the
installation in the vehicle's trunk. Ensure sufficient protection against vibrations, dust and dirt.
- Ensure that the input and output cables are sufficiently separated from the power supply cables.
Otherwise interferences may occur.
- Ensure the accessibility of the fuse and the operating elements after installation.
- The reliability and performance of the amplifier depends on the quality of installation. Preferably
consult an expert to install the system, particularly if you want to install several loudspeakers.
10
ZXE600/4
4 x 100 W @ 4 Ω
4 x 150 W @ 2 Ω
2 x 300 W @ 4 Ω bridged
2 – 8 Ω
5 – 40 000 Hz (-3 dB)
< 0,5 % (1 kHz)
> 90 dB
0,2 – 6 V low level
0,4 - 10 V high level
10 kΩ
10 – 250 Hz @ 12 dB/octave
10 – 250 Hz @ 12 dB/octave
50 – 250 Hz @ 12 dB/octave
0 - 12 dB @ 40 Hz
4 x RCA (FL/FR & RL/RR)
Via enclosed cable jacks (FL/FR & RL/RR)
Only via the high level inputs
+12 V (9 – 15 V), negative ground
3 x 30 A
248 x 64 x 362 mm