Werbung
Fig. 6)
Mark dimension ("Y") on rear of cupboard
door at left and right, measuring down from
top edge of door.
This automatically gives the required gap of
8 mm between facia frame and cupboard
loor.
Fig. 19)
Lay the template across the door with the
line "A" going through the 2 points just
marked on the door. (Remove foil from ad-
hesive strips beforehand.) Adjust template
sideways so that it is symmetrically posi-
tioned on the door, as shown by the mar-
ae at each side, then stick template to
oor.
Mark the 4 hole centres through the tem-
plate onto the door.
Remove parallelograms from door; to do
this, turn knurled screws on appliance door
to the right until they are clear, lift parallelo-
grams up and off, then open them and fit
the 2 supplied wire U-pieces.
re ©
Place parallelograms against cupboard door
with the upper and lower slots over the
4 holes just marked.
Screw the 4 screws centrally into the slots.
Fit the supplied sliders to the lower edge of
the cupboard door, at right and left.
Hang cupboard door against appliance
door, then secure in place by tightening
knurled screws down.
Lift cupboard door up slightly and remove
U-pieces, then release door.
Check functioning of door mechanism by
opening and closing several times.
The wood door must fit squarely against the
appliance and the parallelograms must
operate without there being any rubbing
against the door aperture. Adjust the loca-
tions of the screws in the slots if necessary,
then remove wood door and parallelograms
and fit the remaining securing Screws.
Fig. 11)
If the wood door has a border, do not fit the
inner screws to the parallelogram (the wood
may be too thin).
Fig. 12)
Adjust door balance through the holes at
right and left in the foot panel. Using a
screwdriver, turn adjusters an equal amount
to the right (+) if door comes down too
quickly, or to the left (-) if it does not
come down enough. Locate the appliance in
its final position in the aperture, then secure
it to the worktop with screws through the
brackets.
Setting Plinth Set-Back
Lower the behind cover panel to the floor.
Lower the front cover panel to the floor.
Advice
This appliance must be built-in to a kitchen
only as shown in Fig. 2.
Werbung
