Werbung
Installation- and Setting-Up Instructions,
Integratable Dishwasher
rs. ©
Because of its special design features, this
dishwasher can be integrated optimally in
any row of kitchen appliances and cup-
boards.
The door from a 60 cm lower cupboard with
drawers is required. In case of difficulty in
eng
this, consult your kitchen furniture
dealer.
Unpacking
Take out the foam strips, padding and in-
stallation materials from the basket inside
the appliance.
Fig.
ER
Setting-Up
Stick the vapour protection foil (A) to the
underside of the worktop, without any
creases. Hook securing brackets (B) onto
appliance.
Stick spacer (C) to the appliance side wall
to give the correct spacing from the adja-
cent-cupboard/appliance.
Adjusting Appliance Height
Take off plinth.
Attach supplied sliders to the rear feet.
Unscrew feet until the desired height is ob-
tained.
Push appliance into aperture until the front
of the door is flush with the adjacent cup-
board doors; adjust front feet until the upper
edge of the appliance touches the under-
side of the worktop.
Connect-Up Appliance
See supplied User Instructions.
This work should be carried out only by
qualified personnel.
Electrical connection should not be made
until all other installation work has been
completed.
Fig.
&
Match the Vario control facia to the kitchen
cupboard drawers by adjusting its height; on
the kitchen cupboard, measure the dimen-
sion of the drawer front from the lower edge
of the work surface to the lower edge of the
drawer, subtract 5 mm, then mark the resul-
ting dimension of the Vario control facia.
Fig.
©
"
Loosen the 2 plastic screws by turning them
anti-clockwise. Pull the complete control
facia block off forwards.
‚
Fig.
5)
Adjust the control facia block to the required
dimension by removing individual sections
(5, 10, 15, 20 mm), then stick the remainder
together again.
rs ©
Slide the adjusted control facia block into
the cutout in the control panel. Insert the
plastic screws fully, with the flattened side
towards the appliance door, then secure
them by turning them clockwise.
Fitting Wood Door
Determine positions for securing screws on
the cupboard door.
ri. @
Measure distance ("Y") from lower edge of
facia frame to notch in parallelogram.
Werbung
