Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Hardened material is removed from the nozzle.
Caulk tube is not damaged or frozen.
Plunger rod is free of caulk/adhesive materials.
If the motor continues to shut off, try another tube of material or take the
tool to an authorized service center.
4. Carefully move the caulk gun at an even pace along the gap to be filled
as you continue to depress the switch trigger. Make sure the caulk comes
in full contact with both application surfaces. If necessary, use your finger
to gently press the caulk into a corner or crack.
NOTE: The best fill is usually achieved by pushing the caulk out into the
gap in a forward motion. However, in some cases (particularly where the
side materials are rough or uneven), a pulling motion may work better as
the cartridge will be less likely to get snagged along the joint.
5. The motor will shut off automatically when a caulk tube becomes
empty. Pull the plunger rod back and replace the caulk tube as necessary.
6. To end the caulk bead (A), release the switch trigger.
7. Draw a moistened finger or other "smoothing tool" along the caulk
bead after applying. This will help the caulk adhere to the application
surfaces and will create a clean, finished appearance.
8. Use a damp towel or rag to clean off any excess caulk.
CARE AND MAINTENANCE
WARNING: When servicing, use only identical replacement parts. Use
of any other parts could create a hazard or cause product damage.
WARNING: To avoid serious personal injury, always remove the
batteries from the product when cleaning or performing any maintenance.
１３
-
Werbung
