Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Applying caulk
Fig. 5
1. Prepare the surface to be caulked by removing any dust, dirt, or
remnants of old caulking. Make sure the area to be caulked is clean and
dry.
2. Hold the gun at a slight angle. If filling a crack, insert the spout into the
crack, if possible; otherwise, run the caulk gun along the surface.
3. Squeeze the trigger allowing the caulk to extrude from the tube tip.
NOTE: If the bead of caulk is too narrow, re-cut the nozzle to provide a
larger opening. However, it is better to apply a thin bead of caulk and add
a little more if necessary than to apply too much and attempt to remove
the excess.
NOTE: if there is blocked, you can release the switch trigger and the
plunge rod (1) will be automatically unlock and back off, check and make
sure that:
Nozzle tip is cut.
Inner seal in the caulk tube is broken.
１２
-
Werbung
